Answer: -4m-10< -22 and -8>22
Step-by-step explanation:
Based on the above scenario, the sales director conducted an <u>experiment</u>.
- Because a treatment <u>was </u>applied to the sales representatives.
- The the best statistical study for this situation because the sales director is trying to establish <u>correlation</u>.
<h3>What is an experiment?</h3>
An experiment is known to be a method that is et up with the aim to test a given hypothesis as a component of a scientific method.
In an experiment, there are the two key variables which are the independent and dependent variables. The independent variable is known to be a controlled or it is tested against the dependent variable.
See full question
Part A.
The sales director conducted a.) an experiment b.) a survey c.)an observational study because a treatment a.) was not b.)was applied to the sales representatives.
This is the best statistical study for this situation because the sales director is trying to establish a.) causality b.) correlation.
Learn more about experiment from
brainly.com/question/17274244
Answer:
A. GF
Step-by-step explanation:
The shortest side in a triangle is opposite the smallest angle
<d = 180 -52 -61 =67
The smallest angle is 52 so the smallest side is DG
<f = 180 - 48-85 =50
The smallest angle is 48 so the smallest side is FG
The smallest angle is 48 so the smallest side overall is FG (GF)
If you dont know. use x as your original value. Therefore. you would have:
x - 15 + 9
after the second stop you would have:
(x - 15 + 9) - 4
So your answer would either be...
There was ______ more people on the bus before 2:30 than there was after the second stop.
There was ______ more people on the bus after the second stop than there was before 2:30.
Answer:
The output for NAND gate is false if all the inputs are true. it is true if either A or B is False.
Step-by-step explanation:
Step1
NAND operator:
NAND is a logic or Boolean expression and is a combination of NOT and AND Gate.
NAND gate is built using various junction diodes and transistors.
Step2
The output of NAND can be 0 or 1. Here, LOW (0) and HIGH (1). 0 or 1 is commonly named as FALSE or TRUE respectively.
It is basically the complement of AND gate. If all its inputs are True or 1, then the output is False or 0 else if either A or B is 0 or 1 then it will give the output as TRUE.
Step3
Here, A and B are 2 inputs used to make the truth table for NAND.
In 1st row, when A and B are both 0, the output for NAND is 1.
Likewise, in 2st row and 3rd row, when either A or B is 0 or 1, the output for NAND is 1 that is TRUE.
But in last row, when both inputs A and B are true, then the output for NAND gate is FALSE or 0.
The diagram and truth table for NAND is shown below.
