Answer:
A rule with tapered end
Explanation:
When measuring the depth of a drilled hole that has a small diameter, you should measure at the outside wall of the hole to get the full depth of the diameter part called full diameter depth measurement. However, a depth micrometer can be used to get the measurement.
Answer:
Among us is the answer
Explanation:
If you play among is everyday then Among us is always the answer
Answer:
Adding the length of the tape measure case.
The answer is D. To your question above
Answer:
Both end hinge-Pcr= 0.98 MN
Both end fix-Pcr=3.9 MN
Explanation:
E= 200 GPa
L=2 m
b=7 cm =70 mm
The critical load given as
For square section
Lets take column is hinge at the both ends :
Now by putting all the values
L'= L
Pcr=987371.6 N
Pcr= 0.98 MN
Therefore critical load = 0.98 MN
When both end fixed :
L' = 0.5 L
Pcr=3.9 MN
Therefore critical load = 3.9 MN