No, they actually travel through the vacuum of outer space, but it also requires the absence of a material sedium.
The percentage error in calculated value of the refractive index of acrylic block is calculated using the formula: (true value - calculated value/true value) × 100%.
<h3>What is refractive index of a refracting medium?</h3>
The refractive index of a medium is the ratio of the sine of the angle of incidence on the medium and the sine of the angle of refraction.
- Refractive index = sin i/sin r
where;
- i is the angle of incidence
- r is angle of refraction.
The refractive index of a medium increases with density of the medium.
To determine the percentage error in determining the refractive index of a medium, the following formula is used:
- Percent error = error/true value × 100%
Therefore, the percentage error in calculated value of the refractive index of acrylic block is the ratio of the error and true value multiplied by 100%.
Learn more about refractive index at: brainly.com/question/83184
Hudson Bay is the restricted basin that has the coolest temperatures
Hudson Bay is a restricted basin which remains frozen or is dominated by ice over the summer solstice and through- out much of the high-sun season. This basin experiences a harsh continental climate.
The average annual temperature in almost the entire bay is around 0 °C (32 °F) or below. In the extreme northeast, winter temperatures average as low as −29 °C or −20.2 °F. The region of this basin has very low year-round average temperatures.
This basin starts freezing up by early November, and the northern part of the basin is typically entirely iced over by the end of the month.
correct answer is Hudson bay
learn more about basin :
brainly.com/question/11871406?referrer=searchResults
#SPJ4
The most effective way to clean a science desks is to use a soapy water solution to clean tables using a clean disposable paper towel. Second, after cleaning the table surface with soap or detergent and rinsing with water, disinfect tables by using a diluted bleach water solution
Explanation:
Two waves with the same wavelength are in phase if there phase difference is zero or an integral multiple of wavelength. Thus the integer part of any difference expressed in wavelength can be discarded.
The phase difference of 5.4 wavelength is equivalent to is one of 0.4 wavelength thus the interference is an intermediate interference close to fully destructive.
