Answer:
Explanation:
Hello there!
In this case, when performing units conversions involving two proportional factors we need to make sure we first convert to the base unit and then to the target one; thus, since 1 kg = 1000 g and 1 g = 1000 mg, we set up the following expression:
Best regards!
<span>a. Use PV = nRT and solve for n = number of mols O2.
mols NO = grams/molar mass = ?
Using the coefficients in the balanced equation, convert mols O2 to mols NO2. Do the same for mols NO to mols NO2. It is likely that the two values will not be the same which means one is wrong; the correct value in LR (limiting reagent) problems is ALWAYS the smaller value and the reagent producing that value is the LR.
b.
Using the smaller value for mols NO2 from part a, substitute for n in PV = nRT, use the conditions listed in part b, and solve for V in liters. This will give you the theoretical yield (YY)in liters. The actual yield at these same conditions (AY) is 84.8 L.
</span>and % will be 60%.
4) 6!!!!!!!!!!!!!!
Nanananabxnjajakaz
You need to find the abundance. Then, multiply the abundance by 100, and add that to the mass for each isotope. Basically, for each isotope, take the percentage abundance and add it to the mass. Multiply each calculation of these together to get your average atomic mass,
In order to calculate the final concentration of a dilution, it is important to memorise and remember the following equation:
C1V1/C2V2
Where:
C1 = Initial concentration
V1 = Initial volume
C2 = Final concentration
V2 = Final volume
We are given three of the four, and we are asked to calculate the final concentration in moles, so we may substitute these given values into our equation as follows:
C1V1 = C2V2
(2.00m)(50.0 mL) = (C2)(500mL)
100 = C2(500mL)
C2 = 0.2 m
In the final step, we simply divide 100 by 500 to get our final concentration value.
