Answer:
Redundant paths can be available without causing logical Layer 2 loops.
Explanation:
- Spanning Tree Protocol is used to allow redundancy in the Layer 2 switched networks without creating cycles/circles also called loops.
- These loops are called physical loops.
- When two parts of the switched network are connected via two or more Layer 2 switches this result in a loop.
- This affects the performance of the network as the result of broadcast packets flooding.
- STP puts one port of the switch to forward mode and the rest of the ports within the same part of the network to the blocking mode to avoid broadcast packet flooding. STP puts all the ports that are allowing redundant paths to block mode and the one port that is left after this is placed in forward mode.
- Spanning Tree Algorithm is used by STP to determine the optimal path of switch to the network.
- Bridge Protocol Data Units are used to share the information about the optimal path determined by the spanning tree algorithm with other switches.
- This information helps STP to eliminate the redundant paths.
- So this is how STP tracks all the links in the switched network and eliminates redundant loops by allowing only one active path to the destination while blocking all other paths.
Answer:
whats the question
Explanation:
wont show anything on the doc
Answer:
Click on the New Slide icon. 2.
Enter the slide position desired. N/A
Click where you want to add the slide. 1.
Select New Slide from the Tools menu. 3.
Switch to the Normal or Slide Sorter view. 4.
Switch to the Notes or Outline view. 5.
Explanation:
You can never enter the slide position desired, and you need to click on the slide after which you want the new slide to be placed. Thus, enter the slide position desired is not applicable, and you need to click where you want to add the slide, and more accurately after which. Hence, this is the 1st. Now you need to click on the new slide icon. Then you need to select the new slides from the tools menu. The slide will appear in Normal view, and you can design the slide now as well as add the notes. You can then move to slide sorter view to arrange the slides, or you can arrange from the slide tab as well. Finally to check(edit) the notes and outline you can change the view to notes or Outline view. Hence, the above answer.
Keep in mind that through presenter view, you can make the slide show where you can see the slides and your notes, and the listeners can see the slides only.
Its a monitor otherwise the screen on a computer
<span>The Kshiatriyas family</span>
