Answer: The amount of light that enters the pupil is controlled by the Iris
Explanation:
Answer:
Explanation:
Given
mass 

(inclination)=

Let T be the tension in the rope
From Diagram
-----------------1
where 

For block 
-----------2
From 1 & 2




Resistors and reactors, for use over 600 volts, shall not be installed in close enough proximity to combustible materials to constitute a fire hazard and shall have a clearance of not less than<u> 300 mm </u>from combustible materials.
Explanation:
- The hazards associated with high power industrial resistors are primarily due to their open construction, which is necessary for cooling.
- The exposed conductors which make up the resistors can be not only a shock hazard but also a thermal burn hazard.
- When a resistor fails, it either goes open or the resistance increases. When the resistance increases, it can burn the board, or burn itself up.
- Avoid touching non-flammable resistors in operation; the surface temperature ranges from approximately 350 °C to 400°C when utilized at the full rated value. Maintaining a surface temperature of 200°C or less will extend resistors service life.
- Do not apply power to a circuit while measuring resistance. When you are finished using an ohmmeter, switch it to the OFF position if one is provided and remove the leads from the meter.
- Always adjust the ohmmeter for 0 (or in shunt ohmmeter) after you change ranges before making the resistance measurement.
Hello!
Answer:
2000 J
Explanation
Work equation is expressed as:

Where:
F: Applied force
d: traveled distance
α: Angle between the direction of the force and the direction of the movement. (in this case, both of the direction are the same, so the angle is 0°)
By substituting:

Have a nice day!