Diploid cells. Meiosis is the process of cell division by
which involving gametes. Cell division is just the same for sperm and egg
cells, but they have distinguishable descriptions and labels in the process. Spermatogenesis
is for the males’ sperm cells and oogenesis is the process for females’ egg
cells. The cell division of meiosis involves the two phases, respectively
meiosis I and meiosis II. Meiosis I like mitosis is the cell division that
produces diploid cells. These diploid cells are cells that contain a complete
pair of chromosomes which is 46. The result is two diploid cells after the
first meiosis. To provide clear explanation, in contrast haploid cells only
contain 23 chromosomes and are created after meiosis II which is 4 in number.
Answer:
c. extensor digitorum
Explanation:
the extensor digitorum communis extends the phalanges, then the wrist, and finally the elbow. It tends to separate the fingers as it extends them. In the fingers, the extensor digitorum acts principally on the proximal phalanges, acting to extend the metacarpophalangeal joint.
Answer:
X is the concentration of the substance being measured and Y is the response from the instrument that is being used to measure
Explanation:
A calibration curve is the plot of known concentration of substances where x is the increasing known concentration and Y is the response, typically "absorption" taken from the instrument that is used for measuring. This curve is then used to find out the concentration of the unknown substance by using it's absorbance and comparing it with the calibration curve. For example:
Concentrations and absorbance readings are as follows
0.5mg/mL=10 nm
1.0mg/mL=15nm
1.5mg/mL=20nm
2.0mg/mL=25nm
This data is plotted on a calibration curve. Next we measure the unknown substance the absorption is 20nm. We can suggest that the concentration is 1.5 mg/mL. If there are readings that fall inbetwen values then the formulat to calculate the right concentration would be y = mx + b, where m is the slope and b is the y-intercept.
Linear regression uses the modification of the slope formula y= a + bx to best see how the data of the water samples would fit on the slope of the calibration curve. X is the independent variable , b is the slope of the line and a is the y-intercept.
Extrapolation would be the action of calculating data that are outside the calibration curve, assuming the trend would continue.
E)none of the above because guanine doesn't change, only thymine into uracil.
