Answer:
3 A
Explanation:
Using Ohm's law, where I is the current in Amps, V is the voltage in V and R is resistance through the resistor in Ohms
Substituting v for 24 V and I for 8 Ohms we obtain
Therefore, 3 A run through the circuit
Technician B only is right, who says that to avoid warping the cylinder head, the engine must be cold before removing it.
<h3>What is the cylinder head doing in my car?</h3>
The main task of the cylinder head is to close the discharge chamber of the engine from the top. The upper part of the engine is reached the cylinder head, while the lower part is the engine partnership.
The cylinder head sits on the engine and shuts off the combustion chamber. The gap that remains between the cylinder head and the engine is achieved by the head gasket.
<h3>How to recognize signs of possible defects</h3>
If you notice abnormalities in the functioning of your engine, it is advisable to contact a garage as soon as feasible to prevent further injury.
- The signs of cylinder head flaws include:
- You notice a power loss of the machine
- The cooling water temperature is in the red area
- You see oil in the cooling water
- You must supply water and oil after just a short time
- You notice a bad cold start behavior
To learn more about the cylinder, refer
brainly.com/question/23935577
#SPJ4
complete question is,
Technician A only
Technician B only
Both A and B
Neither A nor B
it would be a bc its a sqare?well 3d is like you can say a cube 2d is like flat
Explanation:
Answer:
The area of solar panel needed in Buffalo is 22.83 m²
The area of solar panel needed in Phoenix is 31 m²
Explanation:
<u>FOR BUFFALO</u>:
First we, calculate the the annual power requirement by dividing the energy by the time of 1 year.
Therefore,
Power Requirement = P = 6000 KWhr/(1 yr)(365 days/yr)(24 hr/day)
P = 684.93 W
Now, to calculate the area we use the formula:
Area = A = P/(Annual Insolation)(Conversion Factor)
A = 684.93 W/(200 W/m²)(0.15)
<u>A = 22.83 m²</u>
<u>FOR PHOENIX</u>:
First we, calculate the the annual power requirement by dividing the energy by the time of 1 year.
Therefore,
Power Requirement = P = 11000 KWhr/(1 yr)(365 days/yr)(24 hr/day)
P = 1255.7 W
Now, to calculate the area we use the formula:
Area = A = P/(Annual Insolation)(Conversion Factor)
A = 1255.7 W/(270 W/m²)(0.15)
<u>A = 31 m²</u>
<u></u>
Answer:
Assuming point a is the origin (0,0) than the ball would be at (-3, -2)
Explanation:
Please give brainliest :D