Answer: A. (4, 4) and (4, 5)
Step-by-step explanation:
The same x value maps onto more than one y value.
Complentary angle = 90 degrees
90 - 16 = your answer
Answer: $736.000
Step-by-step explanation:
if u take out the 4 0s in 320.000 u will get 32 if u take out the percent of 23% u get 23 now mutiply 32 and 23 now u get 736 now add 3 0s then you have your answer
Answer: 
Step-by-step explanation:
By definition, an Isosceles triangle has two equal sides and its opposite angles are congruent.
Observe the figure attached, where the isosceles triangle is divided into two equal right triangles.
So, in this case you need to use the following Trigonometric Identity:
In this case, you can identify that:
Substituting values, and solving for "x", you get:
Therefore, the length of BC rounded to nearest tenth, is:
Answer:
To do this, all you need is to draw triangle with each side being 7 cm, and a circle that intersects all three of its corners.
Step-by-step explanation:
- With a ruler and a pencil, draw a 7cm line.
- With a compass set to a radius of 7cm draw an arc centered around the right end of the line.
- With the same compass, still at 7cm, draw an arc centered around the left end of the line.
- These two arcs will intersect on either side of the line (you only need one side, so you only need a small arc in the right place, roughly where you think the third point if the triangle is.
- Where those arcs intersect is the third point on your triangle. Mark that, and then trace two lines from that point to either end of the line segment you started with.
<em>You now have an equilateral triangle with 7cm sides. Next you need to draw the circle</em>
- Measure the halfway point on two of your three lines.
- Draw a line from that each of those halfway points to the opposite corner. The new lines you're drawing will be perpendicular to the edge your measuring against.
- You have now drawn two line segments, and they intersect in the center of the circle. Now take your compass and set its radius to the distance from that center point to one of the three corner points.
- Centered on that middle point, trace a circle with the selected radius.
And you're done!
