The rigging device which are used to move loads without the use of slings, but grip the load by biting down and using jaw tension to secure the load, is lifting clamps.
<h3>What are the rigging devices?</h3>
The rigging devices are used to lift the objects and items when the safety is required. This device is used in the industries.
Types of rigging devices
- Rigging hooks-These rigging device is used when the heavy load need to be lift.
- Lifting clamps-Lifting clamp are used to lift the device with jaw tension to secure the load. In this, there is no use of slings.
- Pulley and blocks-In the load is lifts with the help of block and pulley arrangement. This is a widely used rigging device.
Thus, the rigging device which are used to move loads without the use of slings, but grip the load by biting down and using jaw tension to secure the load, is lifting clamps.
Learn more about the rigging devices here;
brainly.com/question/8430576
#SPJ1
Answer:
C. Welded contacts on the thermostat
Explanation:
Any fault that keeps the heating element heating when it should not is a fault that will cause the symptom described. The details <em>depend on the design of the brewer</em> (not given).
"A short at the terminals" depends on what terminals are being referenced. The device on-off switch terminals are normally connected together when the brewer is turned on, so a short there may not be observable.
"Welded contacts on the thermostat" will have the observed effect if the thermostat is the primary means of ending the brewing cycle. If the thermostat of interest is an overheat protective device not normally involved in ending the brewing cycle, then that fault may not cause the observed symptom.
__
If the heating element is open-circuit, no heating will occur. A gasket leak may cause a puddle, but may have nothing to do with the end of the brewing cycle. (Loss of water can be expected to end boiling, rather than prolong it.)
Answer: the answer will be d because it is the right one to be
Explanation:
Answer:
<h2>hope it helps you see the attachment for further information .....✌✌✌✌✌</h2>
Answer:
B) An increase in pressure can lower the boiling point of a liquid and change the temperature at which it turns to a gas.
Explanation:
B) An increase in pressure can lower the boiling point of a liquid and change the temperature at which it turns to a gas.
