An good example would be using a Bunsen burner to heat water in a tin container. The flame initially heats the tin can by radiating heat. Conduction then transfers heat from the tin can to the water. The convection process causes the hot water to then climb to the top.
<h3>What is Bunsen Burner?</h3>
A laboratory piece of equipment known as a Bunsen burner, which bears Robert Bunsen's name, produces a single open gas flame and is used for heating, sterilization, and combustion. Natural gas, liquefied petroleum gas, such as propane, butane, or a combination, are all acceptable choices for the gas.
<h3>What three types of flames can you get from a Bunsen burner?</h3><h3>Bunsen burner flames come in three primary categories:</h3>
- Because it is simple to notice in a well-lit space, a yellow flame is also referred to as a safety flame.
- Flaming Blue. A burner's specific flame can reach temperatures of 500 degrees.
- Blue Flame in Flames The roaring blue flame setting on a Bunsen burner produces the hottest flames.
To know more about Bunsen Burner visit:
brainly.com/question/743920
#SPJ4
When a solid is heated, the particles are given more energy and start to vibrate faster. ... The temperature at which this change from solid to liquid happens is called the melting point. Each solid has a set melting point at normal air pressure. At lower air pressure, such as up a mountain, the melting point lowers.
Answer:
No, the resulting wave in the diagram does not demonstrate destructive interference. The resulting wave in the diagram shows a bigger wave than Wave 1 or Wave 2. If it demonstrated destructive interference, it would be a smaller wave or a horizontal line. With destructive interference, waves break down to form a smaller wave, or cancel each other out, resulting in no wave formation.