Solution:
It is important because, it has to do operation on so without, data structures and algorithms.
It performs these operation:
1)Take an input
2) Process it
3) Give back the output.
The input can be in any form, for ex while searching for directions on google maps, the starting point and the destination as input to google maps, while logging in to any social sites, We have to give our email and password as input and so on.
Similarly, in the third step, the computer application gives us output in some form or the other.
To make this process efficient, we need to optimize all the three steps.
Here are a few examples:
•] Keep away from windows or vents to prevent it from turning warm.
•] Clean off dust that’s on the computer.
•] Remove all the things that are blocking air to pass to let it cool down.
•] Putting a soft item below the computer is a action that is prohibited as it blocks the airways which causes it to overheat instead put it on a sturdy flat surface to prevent the aforementioned information.
•] To never overcharge your computer too 100% overnight or any time of the day since it overheats and causes battery life to be short, instead put it to charge when you’re conscious while keeping an eye on it, perhaps set a timer/alarm to notify you if you forget.
Answer:
Redundant paths can be available without causing logical Layer 2 loops.
Explanation:
- Spanning Tree Protocol is used to allow redundancy in the Layer 2 switched networks without creating cycles/circles also called loops.
- These loops are called physical loops.
- When two parts of the switched network are connected via two or more Layer 2 switches this result in a loop.
- This affects the performance of the network as the result of broadcast packets flooding.
- STP puts one port of the switch to forward mode and the rest of the ports within the same part of the network to the blocking mode to avoid broadcast packet flooding. STP puts all the ports that are allowing redundant paths to block mode and the one port that is left after this is placed in forward mode.
- Spanning Tree Algorithm is used by STP to determine the optimal path of switch to the network.
- Bridge Protocol Data Units are used to share the information about the optimal path determined by the spanning tree algorithm with other switches.
- This information helps STP to eliminate the redundant paths.
- So this is how STP tracks all the links in the switched network and eliminates redundant loops by allowing only one active path to the destination while blocking all other paths.
Answer: i dont know but have an great day
Explanation:
<span>If the temperature gauge moves up to just below the red zone,you should turn off your air conditioner and turn on your
vehicle's heater. Then immediately </span>find a mechanic or pull over safely and contact a road service.
