<u>Answer:</u> The Young's modulus for the wire is 
<u>Explanation:</u>
Young's Modulus is defined as the ratio of stress acting on a substance to the amount of strain produced.
The equation representing Young's Modulus is:

where,
Y = Young's Modulus
F = force exerted by the weight = 
m = mass of the ball = 10 kg
g = acceleration due to gravity = 
l = length of wire = 2.6 m
A = area of cross section = 
r = radius of the wire =
(Conversion factor: 1 m = 1000 mm)
= change in length = 1.99 mm = 
Putting values in above equation, we get:

Hence, the Young's modulus for the wire is 
The vector which shows the velocity of the yo-yo at this moment is A and is denoted as option A.
<h3>What is Velocity?</h3>
This is referred to the rate of change of distance with time and the unit is metre per seconds.
A shows the direction of motion is same as the direction of velocity and is the tangent at that particular point hence why it was chosen as the most appropriate choice.
Read more about Velocity here brainly.com/question/6504879
#SPJ1
a) An inflated balloon was pressed against a wall after it has been rubbed with a piece of synthetic cloth. It was found that the balloon sticks to the wall. <u>This is because a positive and negative electric charge is produced, therefore the balloon sticks to the wall.</u>
b) When an object is thrown up, it comes back to ground <u>because of gravitational attraction force of earth</u>.
c) Mountaineers suffer nose bleeding at higher altitudes <u>because the oxygen level decreases with increase in altitude, which the body cannot adjust.</u>
d) Foundations of high rise buildings are kept wide <u>because more is the area of contact, less is the pressure efforts. So, foundations are wide so as to decrease the possibility of the building from falling down.</u>
e) Deep sea divers or high altitude fliers wear special suits <u>so as prevent their body from being crushed by the water pressure. Since water pressure is maximum at deep seas and oceans, therefore, more is the risk of being injured.</u>
f) Walls of a dam are thickened near the base <u>so that the dam can handle the kinetic energy pressure and prevent itself from breaking down, which if not, can lead to flooding</u>.
HOPE IT HELPS...
Hi,
The force that acts on hydraulic machine is heavy therefore the content must be something that cannot be compressed by that kind of force, the gas can easily be compressed while a liquid is nearly impossible to.
Answer:
overload
Explanation:
well she does to much to make it hard for herself so it would be overload
sorry if i'm wrong