Answer: B. Tornado
Explanation: <u>A tornado is a violent rotating column of air extending from a thunderstorm to the ground. The most violent tornadoes are capable of tremendous destruction with wind speeds of up to 300 mph. They can destroy large buildings, uproot trees and hurl vehicles hundreds of yards. They can also drive straw into trees.</u>
Answer:
When the motion of the fluid results due to natural means like the buoyancy effect, that is, the elevation of the warmer fluid and the fall of the cooling fluid is termed as natural convection. Boiling water is the everyday illustration of the natural convection, in the process, the passing of the heat takes place from the burner into the pot, and heats the water present at the bottom.
On the other hand, when the fluid is forced to flow in a tube or over the surface by external means like with the help of a fan or a pump is termed as forced convection. The use of a fan on a hot summer day is an everyday illustration of forced convection. An example of effective heat transfer is the sweat produced by our body. Therefore, when one switches off the fan, the air present around the body captivates the water vapor until it gets saturated. It takes place for some time and stops eventually, which makes one feel hotter.
At that time, when the fan is switched back again, the air surrounding the body starts to move again, without completely getting saturated, and thus, evaporation of the sweat takes place that also contains the heat of the body and one feels cooler.
Answer:
C. Speed
Explanation:
Density differences in different materials are able to change the speed of a wave.
- Wave speed is dependent on the frequency and wavelength of a wave.
- As a wave travels from one medium to another, the speed of the wave changes.
- Speed of a wave is medium dependent.
- The denser a medium, the slower the speed of waves will be be.
- A less dense medium will have waves traveling through faster.
Magma, if it's the picture I know of then it would be "C"
Answer: the percentage of acetic acid will be low.
Explanation: The major aim during titration of acids and bases is to determine the endpoint , that is exact point where the acid in the beaker changes colour, (in this case, pink )with an additional drop from the burette containing the base, since it is usually difficult to mark the equivalence point that tells us when all the substrate in the beaker has been neutralized completely with the buretted substance.
Overshooting the end point is an error which can occur when the person involved in the the titration accidently goes beyond this endpoint by adding too much of the substance(base) from the burette into the beaker missing the exact endpoint.
This implies that the person has added too much of the burreted liquid, ie the base than required , making the acid in the beaker to continue to react resulting to a lower concentration of the acid (acetic acid) with excess base.(NaOH)
