More than likely it is c, because I looked over all the answers and c was the best one for the problem
No correlation
A scatterplot is used to represent a correlation between two variables. There are two types of correlations: positive and negative. Variables that are positively correlated move in the same direction, while variables that are negatively correlated move in opposite directions.
Answer:
Step-by-step explanation:
No value of w is given, so we can only tell you the meaning of <em>min(10, w)</em>:
When w < 10, min(10, w) is w.
When w ≥ 10, 10 is the smaller of the two values, so min(10, w) = 10.
8
A. Delivery is $20. One cord is $120.
B. 1 1/2 cord costs $200. ($180 for the cord and $20 for the delivery)
(I can’t see the full problem for 9)
1). Multiply (5400 inches) by (1 foot / 12 inch) then by (1 mile / 5280 foot).
(See explanation at the bottom)
= (5400 inch) x (1 foot / 12 inch) x (1 mile / 5280 foot)
= (5400 x 1 x 1 / 12 x 5280) (inch - foot - mile / inch - foot)
= 0.0852 mile
2). Multiply (16 week) by (7 day/week) then by (24 hour/day)
then by (60 minute/hour) then by (60 sec/minute).
3). Multiply (54 yards) by (3 foot/yard) then by (1 meter/3.28 foot)
and then by (1000 mm/meter)
4). Multiply (36 cm/second) by (3600 second/hour) then by (1 meter/100 cm)
then by (1 mile/1609.3 meter).
5). Look up how many grams in a pound ('P')
Look up how many mL in a gallon ('G')
Multiply (1.09 g/mL) by ( 1 pound/ P gram) then by (1 gallon/ G mL)
6). Multiply (32 foot/sec) by (1 meter / 3.28 foot) then by (60 sec/minute).
Each time I told you to multiply by something, it was always a fraction
where the numerator and denominator are equal, like (60 seconds/minute)
or (1 foot / 12 inch). Since the top and bottom of the fraction are equal, the
value of the fraction is ' 1 ' , and multiplying by it doesn't change the value,
it only changes the units ... that's what this whole exercise is about.
When you multiply, KEEP the units in the product, and then, after you multiply, you can 'cancel' units out of the top and bottom of the product.
Like if you have 'feet' on top and bottom, just cross them out. When you're done, if you did it correctly, the last unit you end up with will be the one you want.
