<h3>
Answer:</h3>
0.387 J/g°C
<h3>
Explanation:</h3>
- To calculate the amount of heat absorbed or released by a substance we need to know its mass, change in temperature and its specific heat capacity.
- Then to get quantity of heat absorbed or lost we multiply mass by specific heat capacity and change in temperature.
- That is, Q = mcΔT
in our question we are given;
Mass of copper, m as 95.4 g
Initial temperature = 25 °C
Final temperature = 48 °C
Thus, change in temperature, ΔT = 23°C
Quantity of heat absorbed, Q as 849 J
We are required to calculate the specific heat capacity of copper
Rearranging the formula we get
c = Q ÷ mΔT
Therefore,
Specific heat capacity, c = 849 J ÷ (95.4 g × 23°C)
= 0.3869 J/g°C
= 0.387 J/g°C
Therefore, the specific heat capacity of copper is 0.387 J/g°C
The temperature stays the same when a solid changes to a liquid because energy is required to break the forces between particles of water therefore changing the state of matter and separating the particles away from each other.
When a liquid boils, the energy is needed by the particles to escape the surface of the liquid and boil. Instead of raising the temperature, the energy goes into the particles' kinetic energy store so it has enough speed to escape the surface of the liquid.
Answer:
V₂ = 2.96 L
Explanation:
Given data:
Initial volume = 2.00 L
Initial temperature = 250°C
Final volume = ?
Final temperature = 500°C
Solution:
First of all we will convert the temperature into kelvin.
250+273 = 523 k
500+273= 773 k
According to Charles's law,
V∝ T
V = KT
V₁/T₁ = V₂/T₂
V₂ = T₂V₁/T₁
V₂ = 2 L × 773 K / 523 k
V₂ = 1546 L.K / 523 k
V₂ = 2.96 L
Answer:
D.) H-O
Explanation:
Polarity is determined based on the difference in electronegativity of the atoms. The greater the difference, the more polar the bond. The general trend is that the atoms in the top-right corner of the periodic table are the most electronegative.
A.) is incorrect because H-H has no electronegativity difference, making it nonpolar.
B.) and C.) are incorrect because their electronegativity differences are not the greatest.
D.) is correct because the electronegativity difference between the H and O is the greatest.
For example we are going to use this unbalanced chemical reaction:
H₂ + O₂ → H₂O.
First, calculate number of atoms (hydrogens and oxygens) on left and right. There is two oxygen and two hydrogen on left and two hydrogen and one oxygen on right.
You can not change molecular formula of compound, only you can put coefficient in fron of compound to balance reaction.
Put 2 in front water to balance oxygen (now you have two oxygens on left and right). But now you have four hydrogens on right, so you must put 2 in fron hydrogen on the left.
2H₂ + O₂ → 2H₂O.
