It means that the national government and its states' share power.
Why the other statements aren't correct:
If the local governments hold more power, that would be confederal system (like the Articles or Confederation).
An oligarchy is a government run by few people.
If the national governmenr holds most or all power, that is a unitary system of government.
Here are the four sentences as required:
- While colonists influenced the government of England through ideologies (such as the idea that government should have limited powers on people, granting them the rights to life, liberty and property), people nowadays can influence the U.S. government via political parties that provide people with alternative approaches on how a government should be run.
- Over time, representative government led by a Prime Minister came to control and <u>replace the king as the main source of power in England</u>, and nowadays, people can influence the U.S. government via elections, where citizens have the power to vote for their leaders.
- Another form in which England was influenced is with the idea of the rule of law: both government and the ones governed must obey the law that limits the powers of government and, this idea also influenced today's U.S government in that people can rely on laws that are publicly issued, equally enforced, and independently adjudicated.
- Another form of influence is that, in 1258, the nobles forced the King John to create a Parliament, that is, the legislative branch of the English government which, in turn, has two houses that divided power and, so does the current U.S government by dividing his powers in three branches (executive, legislative and judicial).
The answer is c Plymouth didn’t have a colony yet.
The difference between the highest and lowest frequencies in a band or collection of frequencies is known as the bandwidth. The bandwidth in a standard North American telephone circuit is 64 Kbps. The amplitude or height of the wave is altered by amplitude modulation.
<h3>
What do you mean by Telephone Circuits?</h3>
The standard line found in telephone circuits is this one. The frequency response of such a line resembles that of a low-pass RC filter. The telephone line loss and consequently the low-pass filter action increase in frequency as a result of the wires' increasing resistance, which causes an increase in I2R wire losses. 14 The frequency response of a 1 km-long, twisted line is reduced by 9 dB at 1 MHz and keeps going down for higher frequencies, Let's suppose that a straightforward, 1 km-long transmission system is required. A pair of 1 km long twisted copper wires may transmit data with a loss of less than 9 dB.
To know more about Telephone visit:
brainly.com/question/20608530
#SPJ4
