Answer:
A. 0
Explanation:
The technician should configure the RAID 0 for Joe.
RAID 0 also referred to as the striped volume or stripe set is configured to allow the fastest speed and the most storage capacity by splitting data evenly across multiple (at least two) disks, without redundancy and parity information.
Also, RAID 0 isn't fault tolerant, as failure of one drive will cause the entire array to fail thereby causing total data loss.
Answer:
Check the explanation
Explanation:
223.1.17/24 indicates that out of 32-bits of IP address 24 bits have been assigned as subnet part and 8 bits for host id.
The binary representation of 223.1.17 is 11011111 00000001 00010001 00000000
Given that, subnet 1 has 63 interfaces. To represent 63 interfaces, we need 6 bits (64 = 26)
So its addresses can be from 223.1.17.0/26 to 223.1.17.62/26
Subnet 2 has 95 interfaces. 95 interfaces can be accommodated using 7 bits up to 127 host addresses can represented using 7 bits (127 = 27)
and hence, the addresses may be from 223.1.17.63/25 to 223.1.17.157/25
Subnet 3 has 16 interfaces. 4 bits are needed for 16 interfaces (16 = 24)
So the network addresses may range from 223.1.17.158/28 to 223.1.17.173/28
Answer:
Check the explanation
Explanation:
Kindly check the attached image below to see the relation and the table names.