Answer:
4 times around
Explanation:
The total number of teeth involved will be the same for each gear. If the front gear is connected to the pedal and it goes around twice, then 2·24 = 48 teeth will have passed the reference point.
If the rear gear is attached to the wheel, and 48 teeth pass the reference point, then it will have made ...
(48 teeth)/(12 teeth/turn) = 4 turns
Answer:
d. low earth orbit (LEO)
Explanation:
This type of satellites form a constellation deployed as a series of “necklaces” in such a way that at any time, at least one satellite is visible by a receiver antenna, compensating the movement due to the earth rotation.
Opposite to that, a geostationary satellite is at an altitude that makes it like a fixed point over the Earth´s equator, rotating synchronously with the Earth, so it is always visible in a given area.
C both A and b cause they are technician both technicians so they both measure out the floor pan reinforcement be designed to transfer collision energy so I say both A and B
Answer:
A continuity test
Explanation:
A continuity test is used to verified that current will flow in an electrical circuit, it performed by placing a small voltage across the chosen path. continuity test ensure that the equipment grounding conductor is electrically continuous and this test is perform on all the cord sets, receptacles that aren't part of a building or structure's permanent wiring, and cord-and-plug connected equipment required to be grounded. example of equipment used in testing current flow in continuity test are Analog multi-meter, voltage/continuity tester etc.
Continuity test and terminal connection test are the two test required by OSHA on all electrical equipment
Answer:
The percentage of the remaining alloy would become solid is 20%
Explanation:
Melting point of Cu = 1085°C
Melting point of Ni = 1455°C
At 1200°C, there is a 30% liquid and 70% solid, the weight percentage of Ni in alloy is the same that percentage of solid, then, that weight percentage is 70%.
The Ni-Cu alloy with 60% Ni and 40% Cu, and if we have the temperature of alloy > temperature of Ni > temperature of Cu, we have the follow:
60% Ni (liquid) and 40% Cu (liquid) at temperature of alloy
At solid phase with a temperature of alloy and 50% solid Cu and 50% liquid Ni, we have the follow:
40% Cu + 10% Ni in liquid phase and 50% of Ni is in solid phase.
The percentage of remaining alloy in solid is equal to
Solid = (10/50) * 100 = 20%
