Answer:
The answer is below
Explanation:
Given that:
ρ = 800 kg/m3, c = 600 J/kg-K, k = 40 W/m-K, Initial temperature = Ti = 1150,
Environment temperature = T = 450 K, Final temperature = T∞ = 325 K
Diameter = 10 mm = 0.01 m, A = 6
The estimated time for cooling process (t) is given as:
The estimated cooling time is 589 s
There are NO “lead weights inside tires”!
Balancing of the entire wheel (rim plus tire ) is done by correctly fitting the tire to the rim to begin with (new tires have printed coloured marks identifying the heavy and light bits), and then by adding balancing weights to the metal rim, usually made of lead but not always.
If you’re recycling rims then yes, remove the weights and recycle those separately.
Answer:
Change in length = 0.1257 mm
Change in diameter= -0.03771mm
Explanation:
Given
Diameter, d = 15 mm
Length of rod, L = 200mm
F = Force= 300N
d = 0.015m
Ep=2.70 GPa, np=0.4.
First, we have to calculate the normal stress using
σ = F/A where F = Force acting on the Cross-sectional area
A = Area
Area is calculated as πd²/4 where d = 0.015m
A = 22/7 * 0.015²/4
A = 0.000176785714285m²
A = 1.768E-4m²
So, stress. σ = 300N/1.768E-4m²
σ = 1696832.579185520Pa
σ = 1.697MPa
Calculating E(long)
E(long) = σ /Ep
E(long) = 1.697E-3/2.70
E(long) = 0.0006285
At this point, we fan now calculate the change in length of the element;
∆L = E(long) * L
∆L = 0.0006285 * 200mm
∆L = 0.1257mm
Calculating E(lat)
E(lat) = -np * E(long)
E(lat) = -4 * 0.0006285
E(lat) = -0.002514
At this point, we can now calculate the change in diameter of the element;
∆D = E(lat) * D
∆L = -0.002514 * 15mm
∆L = -0.03771mm
Answer:
Kitchen sinks can be clogged for a few reasons, food hair, and other things. Overtime, buildup of these things lead to clogging.
A few methods to fix clogging are, baking soda mixture, plunging, and boiling water.
The first method, baking soda mixture, what you do is you pour a cup of baking soda and vinegar down the drain, and place a rubber stopper to cover the drain opening. Wait 10 or more minutes, and take out the stopper, and run hot tap water until it's unclogged.
The second method is plunging. Make sure the sink has enough water to submerge the plunger, and start plunging. While you are plunging, maintain a good seal to get the best results. This usually works, but sometimes it doesn't.
The last method is boiling water. Pour boiling water into the drain, then after a while, the clogged drain should unclog, if it doesn't repeat the process until necessary.
Explanation:
Answer:
This might reduce outage probability because multiple base stations are able to receive a given mobile signal at a time which lead to signal outage decrease or weakness.
