Answer:
the elongation of the metal alloy is 21.998 mm
Explanation:
Given the data in the question;
K = σT/ (εT)ⁿ
given that metal alloy true stress σT = 345 Mpa, plastic true strain εT = 0.02,
strain-hardening exponent n = 0.22
we substitute
K = 345 / 
K = 815.8165 Mpa
next, we determine the true strain
(εT) = (σT/ K)^1/n
given that σT = 412 MPa
we substitute
(εT) = (412 / 815.8165 )^(1/0.22)
(εT) = 0.04481 mm
Now, we calculate the instantaneous length
= 
given that 
= 480 mm
we substitute
=
× 
= 501.998 mm
Now we find the elongation;
Elongation = 
we substitute
Elongation = 501.998 mm - 480 mm
Elongation = 21.998 mm
Therefore, the elongation of the metal alloy is 21.998 mm
Answer:
to make the bace of a building more sturdy
Explanation:
example: the bace of the empire state building is stone very sturdy
Answer: 0.95 inches
Explanation:
A direct load on a column is considered or referred to as an axial compressive load. A direct concentric load is considered axial. If the load is off center it is termed eccentric and is no longer axially applied.
The length= 64 inches
Ends are fixed Le= 64/2 = 32 inches
Factor Of Safety (FOS) = 3. 0
E= 10.6× 10^6 ps
σy= 4000ps
The square cross-section= ia^4/12
PE= π^2EI/Le^2
6500= 3.142^2 × 10^6 × a^4/12×32^2
a^4= 0.81 => a=0.81 inches => a=0.95 inches
Given σy= 4000ps
σallowable= σy/3= 40000/3= 13333. 33psi
Load acting= 6500
Area= a^2= 0.95 ×0.95= 0.9025
σactual=6500/0.9025
σ actual < σallowable
The dimension a= 0.95 inches
Answer:
Most hydraulic systems develops pressure surges that may surpass settings valve. by exposing the hose surge to pressure above the maximum operating pressure will shorten the hose life.
Explanation:
Solution
Almost all hydraulic systems creates pressure surges that may exceed relief valve settings. exposing the hose surge to pressure above the maximum operating pressure shortens the hose life.
In systems where pressure peaks are severe, select or pick a hose with higher maximum operating pressure or choose a spiral reinforced hose specifically designed for severe pulsing applications.
Generally, hoses are designed or created to accommodate pressure surges and have operating pressures that is equal to 25% of the hose minimum pressure burst.
