Answers for this questions are:
1)
trough - lowest point of the wave.<span>
2) crest - highest point of wave.
3) amplitude - distance from rest position to
the crest or thoughs.
4) wavelenght - distance from two consecutive
crest or troughs.
<span>5) rest position - the flat line running through
middle of the wave.</span></span>
so i have to discuss how forlifts are related to actions in the cell. ok easy Answer: Forklifts collect material (protein) and dump it in storage areas. ... A Cytoplasm is like a Fork Lift because they both transport particles or substances around the factory or the Animal. Therefore, forklift and cytoplasm share this analogy of collecting materials and dumping it elsewhere.
Best Answer:<span> </span><span>Cross sections for formation of cesium and rubidium isotopes produced by bombardment of uranium with protons ranging in energy from 0.1 to 6.2 Bev were measured both radiochemically and mass spectrometrically. Independent yields were determined for Rb/sup 84/, Rb/sup 86/, Cs/sup 127/, Sc, su p 129/. Cs/sup 130/, Cs/sup 131/, Cs/sup 132/, Cs/sup 134/, Cs/sup 136/, and, at some e nergies, Rb/sup 83 and Cs/sup 135/. In addition, the independent yield of Ba/sup 131/ and the chain yields of Cs/sup 125/, Cs/sup 127/, Cs/sup 129/, La/sup 131/, Cs/sup 135/, Cs/sup 137/, ion cross sections of the Cs and Ba products on the neutron- excess side of stability decrease monotonically with increasing energy above 0.1 Bev, whereas the excitation functions for independent formation of the more neutron-deficient products in the Cs-Ba region and of Rb/sup 84/ and Rb/sup 86/ all go through maxima. The proton energies at which these maxima occur fall on a smooth curve when plotted against the neutronproton ratio of the product, with the peaks moving to higher energies with decreasing neutron-proton ratio. Under the assumption that the mass-yield curve in the region 125 < A < 140 is rather flat at each proton energy, the crosssection data in the Cs region can be used to deduce the charge dispersion in this mass range. Plots of log sigma vs N/Z (or Z--Z/sub A/) show symmetrical bell-shaped peaks up to a bombarding energy of 0.38 Bev, with full width at halfmaximum increasing from 3.3 Z units at 0.10 Bev to about 5 Z units at 0.38 Bev, and with the peak position (Z/sub p/) moving from Z/ sub A/ -- 1.44 to Z/sub A/ -- 0.85 over the same energy range. At all higher energies, a double-peaked charge distribution was found, with a neutron-excess peak centered at N/Z approximates 1,515(Z/sub p/ approximates Z/sub A/ -- 1.9), and having approximately constant width and height at bombarding energies greater than 1 Bev. The peak on the neutron-deficient side which first becomes noticeable at 0.68 Bev appears to become broader and shift slightiy to smaller N/ Z values with increasing energy, The two peaks are of comparable height in the Bev region, and the peak-to-valley ratio is only approximates 2. The total formation cross section per mass number in the Cs region decreases from approximates 52 mb at 0.1 Bev to about 29 mb at 1 Bev and then stays approximately constant; the contribution of the neutron-excess peak above 1 Bev is about 12 mb. The neutron-excess peak corresponds in width and position to that obtained in fission by approximates 50-Mev protons. The recoil behavior of Ba/sup 140/ lends support to the idea that the neutron-excess products are formed in a lowdeposition-energy process. The recoil behavior of Ba/sup 131/ indicates that it is formed in a high-deposition-energy process. Post-fission neutron evaporation is required for the observed characteristics of the excitation functions of the rubidium isotopes and the neutron-deficient species in the Cs region. The correlation between neutron-proton ratios and positions of excitation function maxima is semiquantitatively accounted for if fission with unchanged charge distribution, followed by nucleon evaporation, is assumed. (auth)
</span>
<span>biological reactions that happen within cells while reducing the complex interactions found in a whole cell. Eukaryotic and prokaryotic cells have been used for creation of these simplified environments[1]. Subcellular fractions can be isolated by ultracentrifugation to provide molecular machinery that can be used in reactions in the absence of many of the other cellular components.
Cell-free biosystems can be prepared by mixing a number of purified enzymes and coenzymes. Cell-free biosystems are proposed as a new low-cost biomanufacturing platform compared to microbial fermentation used for thousands of years. Cell-free biosystems have several advantages suitable in industrial applications</span>
Answer:
I dont undarsatnd 2gebwhsanKM<dwkdwndwkjdwnfwkjdnfkwnfwkf
Explanation:
wnkf mnf wnmd