Answer:
Throughout the clarification section elsewhere here, the definition of the concern is mentioned.
Explanation:
- The stress-strain curve provides designers with a long list of critical parameters that are needed for utility development. Including capacity, longevity, elasticity, apparent viscosity, tension electricity, resilience, as well as flexural strength, a load-pressure assignment gave us several mechanical households at a certain point of operation. It also assists in manufacturing.
- During which the overarching force can inform us about the maximum energy either workload the substance will experience, which could also be inferred within the action of the stress-strain. The dynamic properties can be seen by pre maximum activity because it will be before even the maximum yield intensity as well as the posted maximum would display plastic behavior however after the peak becomes achieved, the natural frequencies continue to decline.
Answer:
The car's instant speed is 20m/s
Explanation:
a = at + an
The above equation is a vector equation
a is the resultant acceleration
at is the tangent acceleration
an is the normal acceleration
See the attached diagram for solution
<h2 />
Answer:
The objective of a properly proportioned concrete mix are:
- To produce the combination of cementitious material, water, and aggregate that meets the requirements of a particular structure, portion of a structure, or series of structures at least cost.
- To produce concrete of the specified properties.
- To produce a satisfactory of end product, such as beam, column or slab as economically as possible.
Cheers!
Answer: c.An accumulator is not used in a system with a receiver/dryer
Explanation:
In a refrigeration system, a condenser is used to transfer heat and this occurs from the refrigerant to the air or water.
Then, the refrigerant then condenses to liquid when the hear has been transferred.
We should note that the condenser is normally mounted in front of the radiator. The receiver/dryer is a storage tank for the liquid refrigerant from the condenser.
The statement that an accumulator is not used in a system with a receiver/dryer is not true. This is because, the accumulator gives protection to the compressor which helps to prevent the failure of the compressor.
Therefore, the answer is C.
