<h3>Answer:</h3>
a) Moles of Caffeine = 1.0 × 10⁻⁴ mol
b) Moles of Ethanol = 4.5 × 10⁻³ mol
<h3>Solution:</h3>
Data Given:
Mass of Caffeine = 20 mg = 0.02 g
M.Mass of Caffeine = 194.19 g.mol⁻¹
Molecules of Ethanol = 2.72 × 10²¹
Calculate Moles of Caffeine as,
Moles = Mass ÷ M.Mass
Putting values,
Moles = 0.02 g ÷ 194.19 g.mol⁻¹
Moles = 1.0 × 10⁻⁴ mol
Calculate Moles of Ethanol as,
As we know one mole of any substance contains 6.022 × 10²³ particles (atoms, ions, molecules or formula units). This number is also called as Avogadro's Number.
The relation between Moles, Number of Particles and Avogadro's Number is given as,
Number of Moles = Number of Molecules ÷ 6.022 × 10²³
Putting values,
Number of Moles = 2.72 × 10²¹ Molecules ÷ 6.022 × 10²³
Number of Moles = 4.5 × 10⁻³ Moles
The rate of entropy change:
The rate of entropy change of the working fluid during the heat addition process is 3 kW/K
What is the Carnot cycle?
- The Carnot Cycle is a thermodynamic cycle made up of reversible isothermal expansion, adiabatic expansion, isothermal compression, and adiabatic compression processes in succession.
- The ratio of the heat absorbed to the temperature at which the heat was absorbed determines the change in entropy.
The entropy of a system:
The rate of heat addition is expressed as,
Q =
The entropy of a system is a measure of how disorderly a system is getting. The rate of entropy generation during heat addition is,
Calculation:
<u>Given:</u>
= 400K
= 1600K
W = 3600 kW
Put all the values in the above equation, and we get,
= = 3 kW/K
The rate of entropy change is 3 kW/K
Learn more about the Carnot cycle here,
brainly.com/question/13002075
#SPJ4
Answer:
See the images below
Step-by-step explanation:
To draw a dot diagram of an atom, you locate the element in the Periodic Table and figure out how many valence electrons it has. Then you distribute the electrons as dots around the atom,
a. Silicon.
Si is in Group 14, so it has four valence electrons.
b. Xenon
Xenon is in Group 18, so it has eight valence electrons. We group them as four pairs around the xenon atom.
c. Calcium
Calcium is in Group 2, so it has two valence electrons. They are in a single subshell, so we write them as a pair on the calcium atom.
d. Water
Oxygen is in Group 16, so it has six valence electrons. The hydrogen atoms each contribute one electron, so there are eight valence electrons.
Chemists often use a dash to represent a pair of electrons in a bond.
potassium reacts the most vigorously.
Answer:
Gas is sometimes measured in cubic feet at a temperature of 60 degrees Fahrenheit and an atmospheric pressure of 14.7 pounds per square inch. Gas production from wells is discussed in terms of thousands or millions of cubic feet (Mcf and MMcf). Resources and reserves are calculated in trillions of cubic feet (Tcf).