Percent composition by mass is calculated (mass of element within compound)/(mass of compound)*100. The lower the total molar mass of the compound, the greater the percent composition of sulfur. In this case, MgS would be that compound, since Mg has the lowest molar mass of the four elements bonded to S.
This uses something called <span>Le Chatelier's principle. It states essentially that any stress put upon a system will be corrected.
In more simple terms, it means that in an equilibrium, such as the equation N2(g) + 3H2(g) <=> 2NH3(g), removing a reactant will cause the system to create more of said reactant to compensate for its loss, or adding excess reactant will cause the system to remove some of the added reactant. For future reference, the same principle applies to products in an equilibrium as well.
In this case, hydrogen gas is a reactant, and hydrogen is being removed. According to </span><span>Le Chatelier's principle, the system will shift to create more hydrogen gas. In essence, it will shift in the direction of the hydrogen gas, so there will be a shift toward the reactants.
To clear something up, Keq will not change, as it is a constant value with constant conditions (such as temperature, pressure, etc.).</span>
Answer:
525.1 g of BaSO₄ are produced.
Explanation:
The reaction of precipitation is:
Na₂SO₄ (aq) + BaCl₂ (aq) → BaSO₄ (s) ↓ + 2NaCl (aq)
Ratio is 1:1. So 1 mol of sodium sulfate can make precipitate 1 mol of barium sulfate.
The excersise determines that the excess is the BaCl₂.
After the reaction goes complete and, at 100 % yield reaction, 2.25 moles of BaSO₄ are produced.
We convert the moles to mass: 2.25 mol . 233.38 g/mol = 525.1 g
The precipitation's equilibrium is:
SO₄⁻² (aq) + Ba²⁺ (aq) ⇄ BaSO₄ (s) ↓ Kps
Answer:
Li(s) + H20(l) --> LiOH(aq) + H(g)
Explanation:
it is already balanced
The primary structure is the amino acids' unique sequence. The polypeptide's local folding to form structures such as the α-helix and β-pleated sheet constitutes the secondary structure. The overall three-dimensional structure is the tertiary structure