<em>The answer is: your GPS unit cannot send signals to the satellite when it cannot reach it by line of sight.
</em>
<em>
</em>
<em>GPS signals are based on frequencies that can be blocked by solid objects (like walls and roofs). A GPS device is using a series of satellites to detect and see where it is physically located. These frequencies are sent from these plates (satellites) and we cannot expect it to go through all kinds of barriers. When you use a GPS inside a building, a wide variety of physical barriers and potential interference sources make it difficult for the device to detect your location accurately.
</em>
<em>
</em>
<em />
Answer:
The output of the following code is "Hello, we are open! Sincerely, the grocery store ".
Explanation:
In the given code firstly we declare the variable that is numApples and numOranges. In this variable we assign value and the datatype of the variable is var. The var datatype can hold any type of data. Then we use the conditional statement. In the conditional statement, we use the OR logical operator. In the if block we check the condition that is if numApples variable value is less then 20 OR numOranges variable value is equal to numApples then it will print "Hello, we are open!". In the else block it will print "Sorry, we are closed!". In the last, we print "Sincerely, the grocery store".So in this question, if block is executed and the additional message is printed.
Answer:
Fault tolerant system
Explanation:
Fault tolerance is the property that keeps a system operating properly in the event of a failure of one of the components within the system
A fault tolerant system enables the system to continue its operation possibly at a reduced level, rather than having the whole system breakdown.
A good security expert understands the need for fault tolerance in a comprehensive security system, as the absence of this can lead to serious security breaches once the whole system is down.
Answer:
The program to question as follows:
Program:
PRINT "NEPAL", 'print message
PRINT ".EPA", 'print message
PRINT ".P", 'print message
Output:
NEPAL
.EPA
.P
Explanation:
In the above Qbasic program code, the three print function will be used to print the given pattern, that can be described as follows:
- The first time the print function is used, which uses a value, that is "NEPAL" to print its value.
- In the second time, again this function is used, that prints a value, that is ".EPA".
- In the last time, the print method accepts a value, which is ".P" to print its value. when the code is executed, it will print the given design.
Answer:
uhmmm human machine whaT?
Explanation:
