Answer:
Class of fit:
Interference (Medium Drive Force Fits constitute a special type of Interference Fits and these are the tightest fits where accuracy is important).
Here minimum shaft diameter will be greater than the maximum hole diameter.
Medium Drive Force Fits are FN 2 Fits.
As per standard ANSI B4.1 :
Desired Tolerance: FN 2
Tolerance TZone: H7S6
Max Shaft Diameter: 3.0029
Min Shaft Diameter: 3.0022
Max Hole Diameter:3.0012
Min Hole Diameter: 3.0000
Max Interference: 0.0029
Min Interference: 0.0010
Stress in the shaft and sleeve can be considered as the compressive stress which can be determined using load/interference area.
Design is acceptable If compressive stress induced due to selected dimensions and load is less than compressive strength of the material.
Explanation:
Answer:
(B) FALSE
Explanation:
view factor 
depends on the surface emissivity and the surface of geometry view factor is the term used in radiative heat transfer. View factor is depends upon the radiation which leave the surface and strike the surface.View factor is also called shape factor configuration factor it is denoted by
This is true. Anything the government does has a positive or negative effect on anything including businesses.
Answer: Due to the way that spur gears work, starters that use them require an offset armature, which is achieved by placing the starter drive in separate gear housing. In starters that use planetary gears, the gears can be contained in an in line drive-end housing.
Explanation: true
Answer:
enables the representation, analysis and communication of various aspects of an information system. These aspects correspond to varying and incomplete views of information systems and the processes therein.
