Answer:
loop
Explanation:
Loop is the one which is used to execute the specific statement again and again until the condition is true.
In the programming, there are 3 basic loop used.
1. for loop
<u>Syntax:</u>
for(initialization, condition, increment/decrement)
{
statement;
}
the above statement execute until the condition in the for loop true when it goes to false, the loop will terminate.
2. while loop
<u>Syntax:</u>
initialization;
while(condition)
{
statement;
increment/decrement;
}
it is work same as for loop and the increment/decrement can be write after or before the statement.
3. do while
syntax:
initialization;
do
{
statement;
increment/decrement;
}while(condition);
here, the statement execute first then, it check the condition is true or not.
so, if the condition is false it execute the statement one time. this is different with other loops.
The windows of death color is blue and with a sad face and says “your pc has ran to a problem and needs to restart. We’re just collecting some error info, and then we will restart it for you
Answer:
Grenstall is most likely using the point system
Explanation:
The point system is a method of job evaluation system that involves measuring performance of workers in an organization and allocating points to identifiable factors such as skills, efforts, training, knowledge and experience based on its performance. It does not focus on entire job functions. The allocated points enables the organization to determine the compensation that is commensurate for a particular position.
Greenstall Inc uses the point system technique of job evaluation system for its managers as their jobs were broken down based on their skills, mental and physical efforts, training, and responsibility with points being allocated to each of these factors which are then summed up.
Answer:
Redundant paths can be available without causing logical Layer 2 loops.
Explanation:
- Spanning Tree Protocol is used to allow redundancy in the Layer 2 switched networks without creating cycles/circles also called loops.
- These loops are called physical loops.
- When two parts of the switched network are connected via two or more Layer 2 switches this result in a loop.
- This affects the performance of the network as the result of broadcast packets flooding.
- STP puts one port of the switch to forward mode and the rest of the ports within the same part of the network to the blocking mode to avoid broadcast packet flooding. STP puts all the ports that are allowing redundant paths to block mode and the one port that is left after this is placed in forward mode.
- Spanning Tree Algorithm is used by STP to determine the optimal path of switch to the network.
- Bridge Protocol Data Units are used to share the information about the optimal path determined by the spanning tree algorithm with other switches.
- This information helps STP to eliminate the redundant paths.
- So this is how STP tracks all the links in the switched network and eliminates redundant loops by allowing only one active path to the destination while blocking all other paths.
Aerial Lifts,
Vertical Masts and Hydro Platforms,
Telehandlers,
Excavators,
Skid Loaders,
Backhoes,
Cranes,
Air Compressors.
If It was helpful, can you make me brainliest please?
