30 mL. The two compounds need to balance each other out.
Answer:
A)The characteristic frequency to look out for is 1720-1740 cm-1 (for C=O) for which will disappear in the end product but initially present in the reactant.
B)Characteristic frequency present in the infrared spectrum will be at a peak of 3300-3400 cm-1 which will be due to O-H stretch.
C)If the product is wet with water there will be no change in the infrared spectrum
Explanation:
The characteristic frequency to look out for is 1720-1740 cm-1 (for C=O) for which will disappear in the end product but initially present in the reactant.
Characteristic frequency present in the infrared spectrum will be at a peak of 3300-3400 cm-1 which will be due to O-H stretch.
If the product is wet with water there will be no change in the infrared spectrum
Answer:
The correct answer is - 2770000 cm.
Explanation:
1 kilometer = 1000 meter
1 meter = 100 centimeter
1 kilometer = 100*1000 cm
1 km = 100000 cm.
then,
27.7 kilometers = 2.77 × 10^6 centimeters
So, 27.7 kilometers = 27.7 × 100000
= 2.77 × 106 or 2770000 centimeters.
An incandescent bulb becomes hotter than a fluorescent bulb when turned on because in a regular incandescent bulb, there is tungsten wire where electricity is converts into heat. A regular incandescent light bulb requires 4 times more energy than a fluorescent bulb in order to produce the same amount of light. The conversion is such that for a 75-watt bulb, temperature get raised to approximately 2000 K. For such a high temperature, the radiating energy from the wire have some visible light. In such bulbs, 90% of the electricity get consumed in producing heat and only 10% produces light thus, they are not much efficient source of light.
On the other hand, fluorescent bulbs produce light with less amount of heat. In them, 40% of electricity is consumed in producing light and 60% in heat which is very less as compared to heat produced by a incandescent bulb. This is because when it get turned on, mercury atoms inside the bulb collides with electrons and produce UV light which is then converted into visible light using thin layer of phosphor power present inside the bulb. This produces low amount of heat thus, the bulb stays cooler, the bigger size of bulb also helps in dispersing heat.
Therefore, a fluorescent light bulb is not as hot as an incandescent light bulb.
It’s A. Land heats up and cools quickly then water
