Answer:
NO2
Explanation:
Calculate moles of Nitrogen and oxygen (assume total mass is 100g as you only have percentages therefore there is 63.6g of N and 36.4g of O) This is the ratio that they are in but you need the ratio to be in whole numbers therefore divide each number of moles by 2.275 (the moles of oxygen) to calculate the empirical formula. Hope this helps!
Answer:
[C]
Explanation: -Cause i took the test on engenuity
Answer:
Explanation:
Liquid-liquid extraction is a very useful method to separate components from a mixture. It consists of separating one or several substances dissolved in a solvent by transferring them to another solvent insoluble or partially insoluble in the first. The transfer of matter is achieved by direct contact between the two liquid phases.
For the extraction process, the solution is placed in a separating funnel, a water-immiscible organic solvent is added (ethyl ether is the most used), the solution with the compound to be separated, the funnel is covered and the funnel is top. Then it shakes. Depending on the solubilities and density, different layers are observed. The denser the compound, the more it will sink.
Since the organic compound is usually much more soluble in ether than in water, most of the organic compound will be dissolved in the ether phase (upper phase) and inorganic salts, which are not soluble in ether, will remain in the aqueous phase ( lower phase). Subsequently, by separating the separating funnel the two phases are separated, the organic phase is collected.
Occasionally, after stirring, the two immiscible liquids do not separate sharply, forming an emulsion in the intermediate zone. This is called the colloidal suspension of a liquid in another (system consisting of two or more phases, usually a liquid and another dispersed in the form of generally very fine solid particles). One of the reasons for the formation of an emulsion is when the two phases have similar densities. Then the relative density of the organic solvent and water cannot always be relied upon, although there are methods to facilitate the complete separation of the two phases.
Answer:
Heat will flow from the hotter object to the colder. The molecules in the hotter object will slow down and the molecules in the colder object will speed up. Eventually they will get to the point where they have the same temperature. This happens all the time around you.
Explanation:
30.962
34500
28512
31860
answer:
7.49 x 105 mm
0.45 miles
885 yards
34500 inches
reason:
I converted all the measurements to inches.
First, I multiplied 7.49x105 to get 786.45mm
Then, I divided it by 25.4 to get about 30.92 inches
Next, I converted 0.45 miles to inches by multiplying it by 63,360 to get 28,512 inches
For the yards, I took 885 and multiplied it by 36 to get 31,860 inches
Since the last one was already in inches, all I needed to do was put them in order from least to greatest
