Answer:
66800 J
Explanation:
From the question given above, the following data were obtained:
Mass (m) = 200 g
Heat (Q) required =?
The heat required to melt the 200 g sample of water can be obtained as:
Mass (m) = 200 g
Latent heat of water (L) = 334 J/g
Heat (Q) required =?
Q = mL
Q = 200 × 334
Q = 66800 J
Thus, 66800 J of heat energy is required to melt the sample of water.
Firstly the limiting reactant should be identified. Limiting reactant is the reactant that is in limited supply, the amount of product formed depends on the moles present of the limiting reactant.
the stoichiometry of x to y = 1:2
1 mole of x reacts with 2 moles of y
if x is the limiting reactant, there are 3 moles of x, then 6 moles of y should react, however there are only 4 moles of y. Therefore y is the limiting reactant and x is in excess.
4 moles of y reacts with 2 moles of x
since there are 3 moles of x initially and only 2 moles are used up, excess amount of x is 1 mol thats in excess.
Answer: I think you did nothing wrong
Explanation: I think you did nothing wrong
Assuming that the nests are bird's nests and the data is a data gathered by the biologists about those nests.
A hurricane would cause some damage to the nests that is existent and cause a remarkably low count even during breeding season. It would also influence later birds because of population weakening due to the hurricane.
I believe the answer I’d D
Hope it helps