Answer:
1.5106 cm
Explanation:
The beat frequency is equal to the absolute value of the difference between the frequencies of the two signals:
using the wave equation, we can re-write each frequency as
where c is the speed of light and 
is the wavelength. Therefore,
where:
is the beat frequency
is the wavelength of the first generator
is the wavelength of the second generator
We also know that the second generator emits the longer wavelength, so we already know that the term inside the module is positive. Therefore, we can now solve for :
The (more) speed an object has, the (lower) the potential energy and the (higher) the kinetic energy. (I believe that is correct but it’s been a while since I’ve done this)
Answer:
Tension in the chains - In a chain drive, technically, you have a closed-chain (which has no end) going around 2 pulley or gears; looking closely you have 2 parallel chains going in opposite direction. If kept in horizontal direction, the one below the other is the slack side and the other the tight side. The tension on the upper or tight side is more than the slack side. So you need to keep in mind to keep your chain drive tight so that there is no loss or rotation or lags.
Sizes of the pulley/gear - The chain will be warped around a pair of pulley or gear. The sizes of these pulley/gear will also determine the efficiency of the chain drive (consider one big and one small)
Number of pulley/gear - If the number of pulley/gear is more and chain wrapped on it with little complexity will result in decrease in efficiency because of extra tension.
Length of the chain drive - You cannot have much too long chain drive. It will make your slack side more heavy because the end are further away. You have to apply more power and possibilities of lag increases decreasing efficiency. In an ideal situation, this won't happen, but this world isn't ideal.
Friction between chains & pulley/gear - If you have studied gears (involving its teeth), you will come to know that there is friction offered on the two meeting surfaces.
Angle of contact - This would have been explained better with a diagram. Although, if you are familiar with the terms you won't have difficulty understanding. Angle of contact is the angle the chain forms with the pulley/gear at the point of contact with the center of the pulley. The angle of contact should not be too small, or else the things will be slippery.
Explanation:
Answer:
a = 9.8 m/s²
Explanation:
Acceleration due to gravity on Earth is constant, which is 9.8 m/s²
Answer:
Explanation:
The region around a charged particle where another charged particle experiences a force of attraction or repulsion is called electric field.
The strength of electric field is defined as the force experienced by the unit positive test charge.
E = F / q
Electric field strength is a vector quantity and it is measured in newton per coulomb.
Where, F is the force of attraction or repulsion between the two charges and q is the test charge on which the electric field strength is to be calculated.
The strength of electric field is more if the field is strong. It means more be the electric field strength at a point more be the electric field.
