0.866 Zn are in 3.67 miles
Answer:

Explanation:
Mass of one tablet = 20 mg
Mass of two tablets = 
Percent that is soluble in water = 40%
Mass of tablet that is soluble in water = 
So, mass of solute is 
Density of water = 1 kg/L
Volume of water = 1 L
So, mass of 1 L of water is 
PPM is given by

Hence, the concentration of iodine in the treated water
.
Answer:
Standard form: (x+3)^2=1/2(y+3)
f(1) = 29
f(-1) = 5
Explanation:
The standard form of a parabola with a directrix that is horizontal is
(x-h)=4(P)(y-k)
Using the vertex form, find the vertex, foci, and the distance from the vertex to the focus or directrix.
It's easier to use the vertex form to plug in values for x.
f(1) = 2((1)+3)^2-3
f(1) = 29
f(-1) = 2((-1)+3)^2-3
f(-1) = 5
A bond is non polar if it is between same atoms and polar if it is between different atoms.
Same atoms are like two dogs of same strength pulling a bone towards towards each other. But when it’s different atoms it’s like a big dog and small dog then the bone is more towards bigger dog. So it’s the same way in bonds.
Bonds are made up of electrons, when the more stronger pulling atom is present than other the electrons are more towards it and as a result we have polar bond. There is development of a kind of a negative pole and a positive pole.
The stronger atom has electrons towards itself so it has a little more negative charge while the other atom has positive charge. This makes bond polar.
So just look for bond between two different atoms, it would be polar.
Look at the pic below to see the answer.
Marked with green is bond between same atoms... one carbon and another carbon so it is not polar and test marked with blue are polar.
Well the answer should have been 10 but since the bonds at 3 and 8 are two of same type we count only one of them.
The answer is 8... well the answer should be 10 otherwise... discuss it with ur teacher
Answer: (2) decreasing the concentration of HCl(aq) to 0.1 M
Explanation: Rate of a reaction depends on following factors:
1. Size of the solute particles: If the reactant molecules are present in smaller size, surface of particles and decreasing the size increases the surface area of the solute particles. Hence, increasing the rate of a reaction.
2. Reactant concentration: The rate of the reaction is directly proportional to the concentration of reactants.
3. Temperature: Increasing the temperature increases the energy of the molecules and thus more molecules can react to give products and rate increases.
(1) Increasing the initial temperature to 25°C will increase the reaction rate.
(2) Decreasing the concentration of HCl(aq) to 0.1 M will decrease the reaction rate due to lesser concentration.
(3) Using 1.2 g of powdered Mg will increase the reaction rate due to large surface area.
(4) Using 2.4 g of Mg ribbon will increase the reaction rate due to high concentration of reactants.