Answer:1. uses a related sample - repeated measures
2. . does not use a related sample--a
Step-by-step explanation:
Question 1.
step1 A repeated measure design is a design which measures a given sample repeatedly over a given time using different conditions or related measures.
step 2:In the treatment for compulsive hoarding, Here, measures are taken two times ie before and after treatment on the same 50 hoarders which shows a repeated measure, also the design is a within related sample of the same 50 hoarders to give measurement at different conditions of treatment for high and low hoarding scores so the design describes a related sample - repeated measures
Question 2:
step 1 ; An unrelated sample occurs when Samples being measured do not depend on each other
Step 2; 1st Sample for comparison by John are random lonely people and Second Sample are random non lonely people. so the two samples are independent on each other and will give different measurement based on quality of sleep. So the design does not use a related sample
Answer:
14)
21√2
15)
Leg: 7√3
Hypotenuse: 14
Step-by-step explanation:
The hypotenuse is √2 as long as each leg. That means the leg is 42/√2. Simplified to make 21√2.
The hypotenuse is always twice as long as the shortest leg on a 30-60-90 triangle. The longer leg is √3 as long as the shortest side.
Answer:
L = 38/W
Step-by-step explanation:
The area of a rectangle is computed by multiplying length by width. For length L and width W in inches, your rectangle has area ...
A = LW
38 = LW
Then the length can be found by dividing the equation by W:
L = 38/W
Answer:
Step-by-step explanation:
to turn a decimal to a percent, multiply by 100.....or if there is a decimal in there, start from the decimal and just move 2 spaces to the right.
2.346 = 234.6%
and just so you know, to turn a percent to a decimal, divide by 100...or move the decimal point 2 spaces to the left