Chemotherapy is when radiation is used to kill cancer cells while sparing healthy tissue cells, also doctors sometimes inject patients with a nuclear tracer to show problematic areas that need to be checked out, and Nuclear power plants use nuclear energy to create a large amount of energy from just a small amount of Uranium. These are just some of the ways nuclear radiation is used to help us.
Answer: lessons and benefits can seem removed from everyday life. ... If they determine a site is significant, it is ... CRM exists because legislators and their con- ... romance of excavation and discovery of the past for ... Archaeology permits intensive study of a single culture over time, removing the myth
Earthquakes along the San Andreas fault in California.
<u>Explanation</u>:
- When the two plates collide with each other, earthquakes occur. The contact between them makes this earthquake possible. The contact forces are responsible for the earthquakes as there is contact between two plates.
- The gravitational force is a force that is responsible for elevated tides happening on the east coast or the Jupiter's moons to remain in orbit. But this is not a contact force as there is no contact between them
- Moreover, Without any contact, the magnetic force is a non-contact as it attracts the pins from a distance.
C. Electrical conductivity, that means it can pass electricity through wires if needed, think of your phone charger as an example
It will take 1.11 min to heat the sample to its melting point.
Melting point = - 20°C
Boiling point = 85°C
∆H of fusion = 180 J/g
∆H of vap = 500 J/g
C(solid) = 1.0 J/g °C
C(liquid) = 2.5 J/g °C
C(gas) = 0.5 J/g °C
Mass of sample = 25 g
Initial temperature = - 40°C
Final temperature = 100°C
Rate of heating = 450 J/min
Specific heat capacity formula:- q = m ×C×∆T
Here, q = heat energy
m = mass
C = specific heat
∆T = temperature change
Melting point = - 20°C
C(solid) = 1.0 J/g °C
∆T = final temperature - initial temperature = -20 - (-40) = 20
Put these value in Specific heat capacity formula
q = m ×C×∆T
q = 25×1.0×20
=500J
The Rate of heating = 450 J/min
i.e. 450J = 1min
so, 500J = 1.11min
1.11 minutes does it take to heat the sample to its melting point.
The specific heat capacity is defined as the amount of heat absorbed in line with unit mass of the material whilst its temperature increases 1 °C.
Learn more about specific heat capacity here:- brainly.com/question/26866234
#SPJ4
