Answer:
6
Step-by-step explanation:
Multiply all three sides by 8 to get x by itself
16/3 < x < 7
5 1/3 < x < 7
so it’s between 5 and 1/3 and 7. the only answer between those two would be 6. 3 and 4 is too less. 5 is also too less.
Answer:
both
Step-by-step explanation:
The sum of an even number of odd numbers is even, while the sum of an odd number of odd numbers is odd.
Answer:
10.9
Step-by-step explanation:
Formula = Number x 100
Percent = 6 x 100
55 = 10.91
Following shows the steps on how to derive this formula
Step 1: If 55% of a number is 6, then what is 100% of that number? Setup the equation.
6
55% = Y
100%
Step 2: Solve for Y
Using cross multiplication of two fractions, we get
55Y = 6 x 100
55Y = 600
Y = 600
100 = 10.91
Answer:
In inequality notation:
Domain: -1 ≤ x ≤ 3
Range: -4 ≤ x ≤ 0
In set-builder notation:
Domain: {x | -1 ≤ x ≤ 3 }
Range: {y | -4 ≤ x ≤ 0 }
In interval notation:
Domain: [-1, 3]
Range: [-4, 0]
Step-by-step explanation:
The domain is all the x-values of a relation.
The range is all the y-values of a relation.
In this example, we have an equation of a circle.
To find the domain of a relation, think about all the x-values the relation can be. In this example, the x-values of the relation start at the -1 line and end at the 3 line. The same can be said for the range, for the y-values of the relation start at the -4 line and end at the 0 line.
But what should our notation be? There are three ways to notate domain and range.
Inequality notation is the first notation you learn when dealing with problems like these. You would use an inequality to describe the values of x and y.
In inequality notation:
Domain: -1 ≤ x ≤ 3
Range: -4 ≤ x ≤ 0
Set-builder notation is VERY similar to inequality notation except for the fact that it has brackets and the variable in question.
In set-builder notation:
Domain: {x | -1 ≤ x ≤ 3 }
Range: {y | -4 ≤ x ≤ 0 }
Interval notation is another way of identifying domain and range. It is the idea of using the number lines of the inequalities of the domain and range, just in algebriac form. Note that [ and ] represent ≤ and ≥, while ( and ) represent < and >.
In interval notation:
Domain: [-1, 3]
Range: [-4, 0]
