Answer:
Density of the liquid.
Explanation:
Density is the mass per unit volume of a substance.
At specific volume of each immiscible substance, the substance with lower relative molecular mass has the lower density and such floats.
Thus, the physical properties that determines the solvent layer that will be on top is DENSITY.
Answer:
B
Explanation:
The four factors that increase the rate of the reaction:
1.Concentration of the reactants
2.Size of the particles
3.Temperature
4.Catalyst
Hello, I Am BrotherEye
Answer:
As the atmospheric pressure decreases with increase in altitude, when a sealed bag of chips is taken to higher altitude then the pressure of the gases inside the bag become greater than the outer atmospheric pressure and apply pressure on the side covering of the chips bag due to which the chips bag expand.
Explanation:
Atmospheric pressure decreases with increasing altitude. Let's assume you tie up a bag at sea level altitude (with little air inside). That air inside the bag is at 1atm as long as you're at sea level.
Now you start going up, your altitude increases and atmospheric pressure decreases (remember what I said in the beginning about atmospheric pressure decreasing with increasing altitude?).
Let's say you reach an altitude where the atmospheric pressure is 0.5atm, the force acting inside the bag which is pushing it outward is now greater than the force acting on it which is pushing it inward (1atm>0.5atm). As a result, the air inside the bag will push the sides of the bag outward, thus inflating it to a point where the pressure inside the bag becomes 0.5atm or the bag stops stretching.
For the same reason, if you bring the same bag down and take it too deep into the earth (at an altitude lower than sea level) or if you inflate the bag at a very high altitude and bring it down to sea level, it will deflate.
Best Of Luck
~
BrotherEye
To do this, you would first add together the molar mass of all involved elements, to find how many grams are in a mole of Cu(OH)2. Keep in mind, the molar mass is equal to the atomic mass of an element in grams. For example the molar mass of copper (Cu) would be 63.55 (with 2 sig. figs.)
Therefore, now we add together the mass of all elements involved.
Cu: (63.55)+O2(15.99x2=31.98)+H2(1.01x2=2.02)
63.55+31.98+2.02= 97.55g per mole of Cu(OH)2.
Now, divide what we have by how much it takes to get a mole of the stuff.
68.1/97.55= 0.698mol Cu(OH)2
