Resistors and reactors, for use over 600 volts, shall not be installed in close enough proximity to combustible materials to constitute a fire hazard and shall have a clearance of not less than<u> 300 mm </u>from combustible materials.
Explanation:
- The hazards associated with high power industrial resistors are primarily due to their open construction, which is necessary for cooling.
- The exposed conductors which make up the resistors can be not only a shock hazard but also a thermal burn hazard.
- When a resistor fails, it either goes open or the resistance increases. When the resistance increases, it can burn the board, or burn itself up.
- Avoid touching non-flammable resistors in operation; the surface temperature ranges from approximately 350 °C to 400°C when utilized at the full rated value. Maintaining a surface temperature of 200°C or less will extend resistors service life.
- Do not apply power to a circuit while measuring resistance. When you are finished using an ohmmeter, switch it to the OFF position if one is provided and remove the leads from the meter.
- Always adjust the ohmmeter for 0 (or in shunt ohmmeter) after you change ranges before making the resistance measurement.
The atoms of some materials have no free electrons in their outer orbits. These electrons are busy doing other jobs, like being shared in the orbits of two adjacent atoms. They are so closely held that it is very difficult to pull them away. Most compounds of carbon and hydrogen are like this.
<span>Plastics, whose molecules are made from long combinations of carbon and hydrogen atoms, have few or no free electrons. This means that plastics are poor conductors of electricity (and they are also poor conductors of heat). hope that helped.</span>
"Most gets converted to heat energy" is the one among the following choices given in the question that describes what <span>happens to the energy put into a machine that does not get used to do useful work. The correct option among all the options that are given in the question is the second option or option "B". I hope it helps you.</span>
Answer:
Therefore the amplitude of the resultant wave is 
Explanation:
The equation of wave:
y=A sin (kx-ωt)
For wave 1:
y₁=A sin (kx-ωt) = 
sin (kx-ωt)
For wave 2:
y₂=A sin (kx-ωt+Φ) = sin (kx-ωt+Φ)
Where A= amplitude=
The angular frequency 
, 
= wave length.
t= time
T= Time period
= phase difference = 
The resultant wave will be
y = y₁ + y₂
= sin (kx-ωt) + sin (kx-ωt+Φ)
{sin (kx-ωt) + sin (kx-ωt+Φ)}
Therefore the amplitude of the resultant wave is
Answer: below
Explanation: Density, mass of a unit volume of a material substance. The formula for density is d = M/V, where d is density, M is mass, and V is volume
