Answer: All of these.
Explanation: Lets take a two-dimensional array alphabet[4][4]
Lets say this array contains the following elements: Example 1
a b c d
l i o n
f e l l
s t e m
These are the strings with same length. So this 2D array can contain strings of same length.
Now lets take another 2D array Example 2
a b c
h i n t
s o
e g g
2D array can have all these above mentioned elements. So it can contain strings of different lengths.
Now consider the Example 2. Some places for the elements are left. This isn't an issue for 2D array. So it can contain uninitialized elements too.
So the answer is All of above.
The correct answer is 1.6
<h2>"<lastmod>" is the right choice for the given scenario</h2>
Explanation:
<update> This tag does not belong to <URL> tag of the site map. Hence this option goes invalid.
<lastmod> This gives details of the date and time when the website content was changed. It will be in "W3C Date time format". This may omit time at times. This is the write answer.
<loc> This contains the URL of the web page.
<changefreq>: How frequently the "web page is likely to get modified". The values which it accepts are: "monthly, always
, daily
, weekly
,hourly, yearly
, never"
Most network behavior analysis system sensors can be deployed in passive mode only, using the same connection methods as network based idpss. Idps works as a network or host based systems. Most Nba sensors can be deployed in passive mode only too. The Nba examines the network traffic.
Answer:
Check the explanation
Explanation:
A packet filter firewall is used as a check point between internal corporate network to the outside internet. It blocks all the inbound traffic from the outside hosts trying to initiate a direct TCP connection to the internal corporate webserver. The network design with firewall is shown in the attached image below:
The figures in the attached image below shows an internal corporate network is protected with a packet filter firewall to minimize the inbound traffic from the external network or an internet. Therefore, the packet filter is used as a check point between the network.
The packet filter blocks all attempts by the outside hosts in order to initiate a direct TCP connection to the internal webserver of the internal corporate network.
Going by the second part of the attached image below can can therefore conclude that:
• Rule 1 specifies that, deny any packet with the destination address 5.6.7.8 if the STN flag of TCP header is set.
• Rule 2 specifies that, allow the inbound email traffic from the external source.
• Rule 3 specifies, allows the Outbound TCP traffic from the internal corporate network.
• Rule 4 specifies, allows outbound Email traffic from the internal corporate network to the external network.
• Rule 5 specifies, block any traffic from any source to the any destination.