First we write the variables already defined:
m = the number of magazine subscriptions sold
n = the number of newspaper subscriptions sold
We now write the system of inequations based on the following facts:
"he earns $ 23 for each magazine subscription and $ 54 for each newspaper subscription that he sells. his goal is to make more than $ 642 per week"
23m + 54n> 642
"I have expectations to sell at least 10 subscriptions per week"
m + n> = 10
Answer:
A system of inequalities that models the given situation is:
23m + 54n> 642
m + n> = 10
-5║4y-11║-3=12
-5║4y-11║-3 +3=12+3
- 5║4y-11║=15
-5/5║4y-11║=15/-5
║4y-11║=-3
4y-11=-3 -5║4y-11║-3=12
4y-11+11=-3+11 -5║4(2)-11║-3=12
4y=8 -5║-3║-3=12
4y/4=8/4 -5 (3)-3=12
y=2 -18≠12
4y-11=3 -5║4y-11║-3=12
4y-11+11=3+11 -5║4(7/2)-11║-3=12
4y=14 -5(3)-3=12
4y/4=14/4 -18≠ 12
y=7/2
No solutions
Answer:
0.875
Step-by-step explanation:
they're proportional.
Answer:
just do the step by step and you'll probably get it because it's quite simple but hard for me to explain so just read this!
Step-by-step explanation:
In making any measurement, the chances are that our results will not be absolutely accurate. We can often compare our results with some standard or accepted value to see how closely they agree. But how much error can be allowed before the result becomes meaningless?
As you may guess, the amount of error that is acceptable varies with the situation. Suppose you measure the distance on a map between your Scarsdale and Mamaroneck and you get a result of 5 miles. If the actual distance is 5 1/2 miles, the chances are this error will have no effect on the trip between the two towns. But if the same degree of error existed in the calculations used to send astronauts to the moon, those people would be in big trouble!
Percentage Error = <u>measured value - accepted value</u> x 100%
accepted value
Suppose, you measured the length of a table and obtained a measurement of 202 cm. A friend also measures the table and obtains a result of 198 cm. To calculate the percentage error in each of the measurements, you need to know the "correct' or “accepted value” of the length of the table. After consulting the manufacturer’s catalog, you find that the table's length is listed as 200 cm in length. This will be used as the accepted value in our calculation.
The calculations of percentage error for the two measurements are shown below. Both measurements show an error of 1%. Your friend has made a measurement which is on the low side of the accepted value and is therefore, negative. You, on the other hand, have made an error on the high side of the accepted value and it is positive.
I dont know the answer but I hope this helped!
(sorry for the inconvenience)
Answer:
Just do -6 - 6×3 and you'll get -24
