1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Olegator [25]
3 years ago
13

To avoid a possible collision with a manned airplane, you climb your unmanned aircraft to yield the right of way. In doing so, y

our unmanned aircraft reached an altitude greater than 600 feet AGL. To whom must you report the deviation?
Engineering
1 answer:
AleksandrR [38]3 years ago
5 0

Answer:

you have to report to the federal aviation administration upon request

Explanation:

An unmanned aircraft can also be a drone it is an aircraft that does not have passengers or a human pilot.

Such an aircraft could be fully autonomous but most times they have a human pilot who controls it remotely.

Now you have to report this deviation to the federal aviation administration. This body is responsible for the enforcement of regulations that have to do with the manufacture, operation and maintenance of aircrafts. The body makes sure there is an efficient and safe system for a navigation and they also control air traffic.

You might be interested in
If the dry-bulb temperature is 95°F and the wet-bulb temperature is also 78°F, what is the relative humid- ity? What is the dew
Sidana [21]

Answer:

Relative humidity 48%.

Dew point 74°F

humidity ratio 118 g of moisture/pound of dry air

enthalpy 41,8 BTU per pound of dry air

Explanation:

You can get this information from a Psychrometric chart for water, like the one attached.

You enter the chart with dry-bulb and wet-bulb temperatures (red point in the attachment) and following the relative humidity curves you get approximately 48%.

To get the dew point you need to follow the horizontal lines to the left scale (marked with blue): 74°F

for the humidity ratio you need to follow the horizontal lines but to the rigth scale (marked with green): 118 g of moisture/pound of dry air

For enthalpy follow the diagonal lines to the far left scale (marked with yellow): 41,8 BTU per pound of dry air

5 0
3 years ago
For some transformation having kinetics that obey the Avrami equation , the parameter n is known to have a value of 1.1. If, aft
ivanzaharov [21]

Answer:

total time  = 304.21 s

Explanation:

given data

y = 50% = 0.5

n = 1.1

t = 114 s

y = 1 - exp(-kt^n)

solution

first we get here k value by given equation

y = 1 - e^{(-kt^n)}   ...........1    

put here value and we get

0.5 = 1 - e^{(-k(114)^{1.1})}    

solve it we get

k = 0.003786  = 37.86 × 10^{4}

so here

y = 1 - e^{(-kt^n)}

1 - y  =  e^{(-kt^n)}

take ln both side

ln(1-y) = -k × t^n  

so

t = \sqrt[n]{-\frac{ln(1-y)}{k}}    .............2

now we will put the value of y = 87% in equation  with k and find out t

t = \sqrt[1.1]{-\frac{ln(1-0.87)}{37.86*10^{-4}}}

total time  = 304.21 s

7 0
3 years ago
If welding is being done in the vertical position, the torch should have a travel angle of?
siniylev [52]

Answer:

Between 35°– 45°

Explanation:

In the vertical position, Point the flame in the direction of travel. Keep the flame tip at the correct height above the base metal. An angle of 35°–45° should be maintained between the torch tip and the base metal. This angle may be varied up or down to heat or cool the weld pool if it is too narrow or too wide

4 0
2 years ago
The high-pressure air system at OSU's Aerospace Research Center is fed by a set of two cylindrical tanks. Each tank has an outer
lana66690 [7]

Answer:

179000 lb

Explanation:

The supports must be able to hold the weight of the tank and the contents. Since tanks are pressure tested with water, and the supports cannot fail during testing, we disregard the air and will consider the weight of water.

The specific weight of water is ρw = 62.4 lbf/ft^3

These tanks are thin walled because

D / t = 4.6 / 0.1 = 46 > 10

To calculate the volume of steel we can approximate it by multiplying the total surface area by the thickness:

A = 2 * π/4 * D^2 + π * D * h

The steel volume is:

V = A * t

The specific weight is

ρ = δ * g

ρs = 499 lbm/ft^3 * 1 lbf/lbm = 499 lbf/ft^3

The weight of the steel tank is:

Ws = ρs * V

Ws = ρs * A * t

Ws = ρs * (2 * π/4 * D^2 + π * D * h) * t

Ws = 499 * (π/2 * 4.6^2 + π * 4.6 * 50) * 0.1 = 37700 lb

The weight of water can be approximated with the volume of the tank:

Vw = π/4 * D^2 * h

Ww = ρw * π/4 * D^2 * h

Ww = 62.4 * π/4 * 4.6^2 * 50 = 51800 lb

Wt = Ws + Ww = 37700 + 51800 = 89500 lb

Assuming the support holds both tanks

2 * 89500 = 179000 lb

The support must be able to carry 179000 lb

3 0
4 years ago
Air is compressed in the compressor of a turbojet engine. Air enters the compressor at 270 K and 58 kPa and exits the compressor
tia_tia [17]

Answer:

Recall the Entropy  Balance (Second Law of Thermodynamics) equations for the system below

And for ideal gas, we know that

Change in Entropy of the air kJ/Kg.K, ΔS = S₁ - S ₂ = Cp Ln (T₂/T₁) - R Ln(P₂/P₁)

where R is gas constant =0.287kJ/kg.K and given

Cp=1.015 kJ/ kg.K

T₂ = 465k T₁=270k, P1=58kPa, P2=350kPa

substituting these values into the eqn above, we have

S = (1.015x 0.544) - (0.287x1.798)

S = 0.0363kJ/Kg.K

Hence, the mass specific entropy change associated with the compression process = 0.0363kJ/Kg.K

8 0
4 years ago
Other questions:
  • The use of seat belts in cars has significantly reduced the number of crash fatalities. Which statement best explains how the ma
    8·2 answers
  • Tadpoles raised in water with atrazine levels of 0.1 ppb should produce a higher percentage of male frogs with gonadal abnormali
    13·1 answer
  • Create a plot of the force of static friction, fsfsf_s, versus the x component of the pulling force, FxFxF_x, for the experiment
    10·1 answer
  • Steam enters a turbine operating at steady state at 800°F and 450 lbf/in^2 and leaves as a saturated vapor at 1.2 lbf/in^2. The
    12·1 answer
  • Calculate the line parameters ????′, ????′, ????′, and ????′ for a coaxial line with an inner conductor diameter of 0.5 cm and a
    13·1 answer
  • Forcing a solid piece of heated aluminum through a die forms:
    15·2 answers
  • Scientists believe that our solar system formed about 4.6 billion years ago from a cloud of hydrogen, helium, rock, ice, dust, a
    13·2 answers
  • PLEASE I NEED HELP!
    9·1 answer
  • What is the eye an example of?<br><br><br><br> sense organ<br> stimulus <br> a relay neuron
    14·1 answer
  • the water level in a tank is 20 m above the ground. a hose is connected to the bottom of the tank, and the nozzle at the end of
    5·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!