Answer:
<em>o</em>-bromotoluene, <em>m</em>-bromotoluene and <em>p</em>-bromotoluene.
Explanation:
Hello,
In this case, on the attached picture you will find the reaction which yields <em>o</em>-bromotoluene as the first product, <em>m</em>-bromotoluene as the second product and <em>p</em>-bromotoluene as the last one since the substitution could be done at the second (ortho), third (meta) or fourth (para) carbons on the toluene.
Regards.
One of the most likely products for the reaction would be 
<h3>Chemical reactions</h3>
The reaction between
and
yields 3 products which are
(a precipitate),
, and
as shown by the equation below:

One of the products precipitates out of the solution to give the reaction a precipitation reaction look.
More on precipitation reaction can be found here: brainly.com/question/24158764
#SPJ4
Consider the halogenation of ethene is as follows:
CH₂=CH₂(g) + X₂(g) → H₂CX-CH₂X(g)
We can expect that this reaction occurring by breaking of a C=C bond and forming of two C-X bonds.
When bond break it is endothermic and when bond is formed it is exothermic.
So we can calculate the overall enthalpy change as a sum of the required bonds in the products:
Part a)
C=C break = +611 kJ
2 C-F formed = (2 * - 552) = -1104 kJ
Δ H = + 611 - 1104 = - 493 kJ
2C-Cl formed = (2 * -339) = - 678 kJ
ΔH = + 611 - 678 = -67 kJ
2 C-Br formed = (2 * -280) = -560 kJ
ΔH = + 611 - 560 = + 51 kJ
2 C-I Formed = (2 * -209) = -418 kJ
ΔH = + 611 - 418 = + 193 kJ
Part b)
As we can see that the highest exothermic bond formed is C-F bond so from bond energies we can found that addition of fluoride is the most exothermic reaction
I believe the correct answer is the first option. To increase the molar concentration of the product N2O4, you should increase the pressure of the system. You cannot determine the effect of changing the temperature since we cannot tell whether it is an endothermic or an exothermic reaction. Also, decreasing the number of NO2 would not increase the product rather it would shift the equilibrium to the left forming more reactants. The only parameter we can change would be the pressure. And, since NO2 takes up more space than the product increasing the pressure would allow the reactant to collide more forming the product.
Since there is one carbon with 4 Fluorines attached to it, and both compounds are no metals, we use the covalent method for naming,
Here we ignore the prefix for the first element if it is 1. Mono. Then pay attention to the second one, it would be tetra, because tetra means 4. Here there are 4 fluorines.
Drop ine and place ide
CF4 = carbon tetrafluoride.