First figure out how many times 9 can go into 25 **do the highest amount of times it can go in-
<span><span>9x1=9 </span><span>9x2=18 </span><span>9x3=27 </span><span>9x4=<span>36
nine can go in 2 times because 3 times would be way to much
so you're mixed number would be 2
now to figure out you're numerator do 25-18=7
Now it would be 2 7/25
so you're mixed number,then the numerator,finally denomantor ALWAYS stays the same.
*IF YOU'RE NUMERATOR AND DENOMANTOR CAN BE REDUCED THEN REDUCE</span></span></span>
Answer:
4. (d, the last one)
5. (a, the first one)
Step-by-step explanation:
Answer:
A construction worker may use trigonometry when building the roof of a house. They may have to calculate the right angle that hypotenuse must sit at so water doesn't build up on the roof and cause leaks.
(this may be more of an architect's job, as they are the ones that design the houses)
or
An air traffic controller may use trigonometry to find how long it will take an airplane to land/how far the airplane is from the ground while it is in the sky (hypotenuse), based on its height from the ground (opposite) and the distance away from the runway it is (adjacent). They can also calculate the angle of elevation of the airplane from the tower they work in.
Part A
<h3>Answer:
h^2 + 4h</h3>
-------------------
Explanation:
We multiply the length and height to get the area
area = (length)*(height)
area = (h+4)*(h)
area = h(h+4)
area = h^2 + 4h .... apply the distributive property
The units for the area are in square inches.
===========================================================
Part B
<h3>Answer:
h^2 + 16h + 60</h3>
-------------------
Explanation:
If we add a 3 inch frame along the border, then we're adding two copies of 3 inches along the bottom side. The h+4 along the bottom updates to h+4+3+3 = h+10 along the bottom.
Similarly, along the vertical side we'd have the h go to h+3+3 = h+6
The old rectangle that was h by h+4 is now h+6 by h+10
Multiply these expressions to find the area
area = length*width
area = (h+6)(h+10)
area = x(h+10) ..... replace h+6 with x
area = xh + 10x .... distribute
area = h( x ) + 10( x )
area = h( h+6 ) + 10( h+6 ) .... plug in x = h+6
area = h^2+6h + 10h+60 .... distribute again twice more
area = h^2 + 16h + 60
You can also use the box method or the FOIL rule as alternative routes to find the area.
The units for the area are in square inches.
36 is a perfect square, but its factors include 1 and 36, 6 and 6, 4 and 9, 3 and 12, and 2 and 18. that's 9 factors, not 3.
