Answer:
The sample rate determines the maximum receive bandwidth of a direct digital conversion SDR. An analog signal must be sampled at twice the rate of the highest frequency component of the signal by an analog-to-digital converter so that the signal can be accurately reproduced.
Explanation:
The formula to get the velocity is V=D/T. First you need to determine the distance and time at a certain point and plug it into the equation and that will be your velocity at that point. To get it between two points you complete the directions two times and find the average or use the slope formula, slope = rise/run; slope = (y2 - y1) / (x2 - x1).
M=meter, km=kilometer, mm=millimeter, mg=micrometer, cm=centimeter
Answer:
Explanation:
Missing question:
What is the object's acceleration?
Solution:
The acceleration of an object is given by
where
v is the final velocity
u is the initial velocity
t is the time taken for the change in velocity
For the object in this problem,
u = +25 m/s
v = +15 m/s
t = 2.0 s
Substituting,
And the acceleration is negative because its direction is opposite to that of the velocity.
Answer:
* The first thing we observe is that the frequency response does not change
* The current that circulates in the circuit decreases due to the new resistance at the resonance point,
Z = R + R₂
Explanation:
The impedance of a series circuit is
Z₀² = R² + (X_L-X_C) ²
when we place another resistor in series the initial resistance impedance changes to
Z² = (R + R₂) ² + (X_L - X_C) ²
let's analyze this expression
* The first thing we observe is that the frequency response does not change
* The current that circulates in the circuit decreases due to the new resistance at the resonance point,
Z = R + R₂
