Answer:
When it's too hot or too cold.
Explanation:
When a bulb of the wrong size or voltage is used in the fixture, the ballast often overheats, causing the light to shut off. The bulbs and the fixture must also match in frequency, or the ballast becomes overworked and overheated.
Answer:
A. 0
Explanation:
The technician should configure the RAID 0 for Joe.
RAID 0 also referred to as the striped volume or stripe set is configured to allow the fastest speed and the most storage capacity by splitting data evenly across multiple (at least two) disks, without redundancy and parity information.
Also, RAID 0 isn't fault tolerant, as failure of one drive will cause the entire array to fail thereby causing total data loss.
Answer:
Option B and C are the correct answer for the above question
Explanation:
The above question asked about the work of the programmer to catch an error of the program--
- Then the option B states that the programmer needs to prints the value of the various program variable on every line of the program which is the correct solution because it is used to find the error easily. It defines the value of every variable in every place of the program and the programmer caught the error statement in the program if anywhere the variable gets the false value.
- The C option states to help from a friend, it is also a good solution because the friend can easily be caught the error of the program by seeing every line of code.
- But the other option is not correct because the option A states that the change the name of the variable which is not a result of anything.
- And the option D states that the code will be retyped again which is also not justify anything.
