Hope this may help you
Problem Solving: Show your solution:
1 answer:
Answer:
(a) λ = 0.1224 m
(b) λ = 12500 m = 12.5 km
Explanation:
The wavelength can be calculated with the help of the frequency of the waves. The formula utilized for this purpose is given as follows:
where,
c = speed of light = 3 x 10⁸ m/s
λ = wavelength of the wave
f = frequency of the wave
(a)
f = 2.45 GHz = 2.45 x 10⁹ Hz
λ = ?
Therefore,
<u>λ = 0.1224 m</u>
<u></u>
(b)
f = 24 KHz = 2.45 x 10³ Hz
λ = ?
Therefore,
<u>λ = 12500 m = 12.5 km</u>
You might be interested in
Let’s create a diagram that shows the chemical reaction absorb energy. Take a look at the diagram I created that is attached to this answer.
Now, the start of the graph line is pretty flat and low leveled. This is the start, which is the reactants. The beginning of a chemical reaction that absorbs energy will almost always start with reactants. I labeled this this “Start: Reactants” and colored the text light green so you can easily detect the part I’m talking about.
Moving on, we see there’s a light blue arrow pointing from the the near bottom to the top curve of the graph line. This is the where the activation energy is rising. Activation energy is the difference between the reactants and products. When the graph line begins to cure, this is when the transition state is beginning. I labeled the transition state, “Transition State” and colored the text a light orange. I colored the line a light blue and also labeled it “Activation Energy” and colored the text light blue as well. I hope it’s easy enough for you to follow along. :)
Next we see that the graph line dips and then goes flat, but it doesn’t go low leveled. It says fairly higher than where it started. This is the end product. I labeled this “End: Product” and colored the text light purple so you can easily detect it.
Okay, now that that’s clear, let’s go ahead and fill in the first blank. According to the diagram we see that the start should be a reactant, and since the graph line starts out pretty low. So, this means that the first tile should be “Low energy of reactants."
Now the second tile should definitely be “Transition State.” This is because the second part in the diagram is transition state. Again, this is mainly where the activation energy is starting to rise.
As for the last and final tile, we should chose “High energy of products.” This is because the diagram is left off on a high leveled part at the end of the graph line.
So, when you place the tiles they should look something like this.
Low energy of reactants
↓
Transition state
↓
High energy of products
- Marlon Nunez
