Answer:
Make sure both cars are in park or neutral with the parking brake engaged. This makes sure that all electrical functions (headlights, radios, etc.) are turned off.
The following scenarios are pertinent to driving conditions that one may encounter. See the following rules of driving.
<h3>What do you do when the car is forced into the guardrail?</h3>
Best response:
- I'll keep my hands on the wheel and slow down gradually.
- The reason I keep my hands on the steering wheel is to avoid losing control.
- This will allow me to slowly back away from the guard rail.
- The next phase is to gradually return to the fast lane.
- Slamming on the brakes at this moment would result in a collision with the car behind.
Scenario 2: When driving on a wet road and the car begins to slide
Best response:
- It is not advised to accelerate.
- Pumping the brakes is not recommended.
- Even lightly depressing and holding down the brake pedal is not recommended.
- The best thing to do is take one foot off the gas pedal.
- There should be no severe twists at this time.
Scenario 3: When you are in slow traffic and you hear the siren of an ambulance behind
Best response:
- The best thing to do at this moment is to go to the right side of the lane and come to a complete stop.
- This helps to keep the patient in the ambulance alive.
- It also provide a clear path for the ambulance.
- Moving to the left is NOT recommended.
- This will exacerbate the situation. If there is no place to park on the right shoulder of the road, it is preferable to stay in the lane.
Learn more about rules of driving. at;
brainly.com/question/8384066
#SPJ1
Diode logic gates are not suitable for cascading operation because the pull-down or pull-up resistance within makes them a high output resistance device.
<h3>What is a
cascading operation?</h3>
A cascading operation can be defined as a process which involves the use of a circuit breaker's current-limiting capacity in order to enable an installation of lower-rated and lower-cost circuit breakers.
According to the National Electrical Code (NEC), diode logic gates are not suitable for cascading operation because the pull-down or pull-up resistance within makes them a high output resistance device.
Read more on National Electrical Code here: brainly.com/question/10619436
#SPJ1
The system includes a disk rotating on a frictionless axle and a bit of clay transferring towards it, as proven withinside the determine above.
<h3>What is the
angular momentum?</h3>
The angular momentum of the device earlier than and after the clay sticks can be the same.
Conservation of angular momentum the precept of conservation of angular momentum states that the whole angular momentum is usually conserved.
- Li = Lf where;
- li is the preliminary second of inertia
- If is the very last second of inertia
- wi is the preliminary angular velocity
- wf is the very last angular velocity
- Li is the preliminary angular momentum
- Lf is the very last angular momentum
Thus, the angular momentum of the device earlier than and after the clay sticks can be the same.
Read more about the frictionless :
brainly.com/question/13539944
#SPJ4
