Answer:
The answer is A) 20 feet by 30 feet
Problem 1
Draw a straight line and plot X anywhere on it.
Use your compass to trace out a circle with radius 1.5 cm. The circle intersects the line at two points. Let's make Y one of those points.
Also from point X, draw a circle of radius 2.5
This second circle will intersect another circle of radius 3.5 and this third circle is centered at point Z.
Check out the diagram below to see what I mean.
=====================================================
Problem 2
Draw a straight line and plot L anywhere on it.
Adjust your compass to 4 cm in width. Draw a circle around point L.
This circle crosses the line at two spots. Focus on one of those spots and call it M.
Draw another circle centered at point M. Keep the radius at 4 cm.
The two circles intersect at two points. Focus on one of the points and call it N.
The last step is to connect L, M and N to form the equilateral triangle.
See the image below.
=====================================================
Problem 3
I'm not sure how to do this using a compass and straightedge. I used GeoGebra to make the figure below instead. It's a free graphing and geometry program which is very useful. I used the same app to make the drawings for problem 1 and problem 2 earlier.
Answer:
y=2/3x+4
Step-by-step explanation:
Answer:
71
Step-by-step explanation:
Take the cost of the item and multiply by the commission percent
800 * 8.875%
Change to decimal form
800*.08875
71
A cube, is made off 6 squarial faces, so all faces on that cube, are squares, the front, back, left, right, top and bottom.
a square has all equal sides, and also all right angles, so all angles in a square are 90°. Let's say the sides are "x" long.
now, if we run a plane on that cube diagonally, check the picture below, the diagonal side at the bottom, by usin the 45-45-90 rule as you see it there, will be x√2.
let's keep in mind that, "x" is opposite side of that angle θ, and then x√2 will be the adjacent side of it.
and we can use those two to get the tangent and then the inverse tangent to get the value, as you see it in the picture.
if you need the angle in radians, run the inverse tangent again, just make sure your calculator is in radians mode.