Answer:
Taking responsibility for your own learning makes it easier to identify your strengths and weaknesses. Once these have been identified you can work on a learning plan that focuses on the areas that you need most help with, increasing the speed of your learning, and build the skills you have been trying to perfect.
Explanation:
Answer:
a) Ef = 0.755
b) length of specimen( Lf )= 72.26mm
diameter at fracture = 9.598 mm
c) max load ( Fmax ) = 52223.24 N
d) Ft = 51874.67 N
Explanation:
a) Determine the true strain at maximum load and true strain at fracture
True strain at maximum load
Df = 9.598 mm
True strain at fracture
Ef = 0.755
b) determine the length of specimen at maximum load and diameter at fracture
Length of specimen at max load
Lf = 72.26 mm
Diameter at fracture
= 9.598 mm
c) Determine max load force
Fmax = 52223.24 N
d) Determine Load ( F ) on the specimen when a true strain et = 0.25 is applied during tension test
F = 51874.67 N
attached below is a detailed solution of the question above
Answer:
Moving a magnet around a coil of wire, or moving a coil of wire around a magnet, pushes the electrons in the wire and creates an electrical current. Electricity generators essentially convert kinetic energy (the energy of motion) into electrical energy.
Answer:
12.332 KW
The positive sign indicates work done by the system ( Turbine )
Explanation:
Stagnation pressure( P1 ) = 900 kPa
Stagnation temperature ( T1 ) = 658K
Expanded stagnation pressure ( P2 ) = 100 kPa
Expansion process is Isentropic, also assume steady state condition
mass flow rate ( m ) = 0.04 kg/s
<u>Calculate the Turbine power </u>
Assuming a steady state condition
( p1 / p2 )^(r-1/r) = ( T1 / T2 )
= (900 / 100)^(1.4-1/1.4) = ( 658 / T2 )
= ( 9 )^0.285 = 658 / T2
∴ T2 = 351.22 K
Finally Turbine Power / power developed can be calculated as
Wt = mCp ( T1 - T2 )
= 0.04 * 1.005 ( 658 - 351.22 )
= 12.332 KW
The positive sign indicates work done by the system ( Turbine )
A jack plane is a general purpose woodworking bench plane, used for dressing timber down to the correct size in preparation for truing and/or edge jointing.
I hope this helps you :)