The reaction between methane gas and chlorine gas to form hydrogen chloride and carbon tetrachloride, all in their gaseous form can be expressed through the chemical reaction below.
CH₄ + 4Cl₂ --> 4HCl + CCl₄
Let us assume that all the involved gases behaves ideally such that each mole of the gas is equal to 22.4 L.
Through proper dimensional analysis, the volume of the produced hydrogen chloride is calculated,
V(HCl) = (1.69 mL CH₄)(1 L CH₄/ 1000 mL CH₄)(1 mol CH₄/22.4 L CH₄)(4 mols HCl/1 mol CH₄)(22.4 L HCl/1 mol HCl)(1000 mL/1 L)
V(HCl) = 6.76 mL
<em>ANSWER: 6.76 mL</em>
Answer:
Nitrobenzene is too deactivated (by the nitro group) to undergo a Friedel-Crafts alkylation.
Explanation:
The benzene ring in itself does not easily undergo electrophilic substitution reaction. Some groups activate or deactivate the benzene ring towards electrophilic substitution reactions.
-NO2 ia a highly deactivating substituent therefore, Friedel-Crafts alkylation of nitrobenzene does not take place under any conditions.
This reaction scheme is therefore flawed because Nitrobenzene is too deactivated (by the nitro group) to undergo a Friedel-Crafts alkylation.
Answer:
Intermolecular forces (IMFs) can be used to predict relative boiling points. The stronger the IMFs, the lower the vapor pressure of the substance and the higher the boiling point. Therefore, we can compare the relative strengths of the IMFs of the compounds to predict their relative boiling points.
Explanation:
27) mechanical weathering
28) overgrowth of algae that produce toxins
29) Weathering breaks down and loosens the surface minerals of rock so they can be transported away by agents of erosion such as water, wind and ice. There are two types of weathering:mechanical and chemical. Mechanical weathering is the disintegration of rock into smaller and smaller fragments.
30) I'M NOT SURE
hope this helps
IN exchange can u mark me as brainlist
Answer:
Exolaiend in explanation section
Explanation:
First of all, the automatic hammer is used to drive nails into tight spaces where where we can't get a sufficient striking force if we are to use a normal regular hammer in driving the nail.
So the nail to be driven is lifted out of rest(it's position). The energy here is gravitational potential energy.
Now, when it is driven into the tight spaces, the gravitational energy would be converted to kinetic energy due to the motion and speed involved.